Search results

One last question… can you just neck size when you use a lever gun like mine? Read two articles and one said no and one said yes😩

SO I AM going to try some HORNADY BRASS Too frustrating. Thanks for all your help

Just google “ three ways to find the lands” The problem with the Hornady tool is that it’s a generic shell case not one that actually works in you rifle. Option is to get one of your fired brass tapped… I don’t have that option. Now they used red locktight but blue works too just have to be...

Here’s the info off the blue locktite bullet You can see I am way off the lands Locktite ogive is 2.2775 and neck was .276 Mine that worked was 2.229 and neck was .272 And even the case length is fine 😩😩

So here’s a comparison of what worked and what didn’t.

Gotter out I took a fired Starline case. I then took a partition ( same ones I am using- 100 grain Nosler). I made sure the bullet would slide easily. I then put a drop or two of blue locktite in the neck Slid the bullet in LONG Slid it in the chamber carefully. I levered the shell in...

Need a new bolt tomorrow Time for bed Bow hunting starts on Sunday Dead critters coming soon

Broken bolt

Now the bolt broke Looks like new die set coming Any suggestions 😩😩😩😩

Sure liking bow hunting… way less hassles

This is absolutely obsurd Now I have another stuck case in the frogging die I think this one shot is useless

Well that was short lived. *+*^^***^*%^%#^^ Still getting some where the brass goes in fine but when I seat the bullet at the same setting ( everything) some don’t work All cut to the same length WT^*%%%%#

WE HAVE SUCCESS.👍👍👍👍 I will just a couple more to make sure and go from there Thanks so much Jer

Ok I got one case to fit. I had to rotate 3/8 turn. So do I put the neck sizer back in and do that one again and then try a few more. I have a turret press so I think I have to do the brass first, back the die out so it can go all the way up to do the rest of the stations ( powder and seating...

I see you can take this apart ( thanks YouTube). So leave the expander ball out now?

Is this the tool that you use to check the bump? Called a headspace comparator for 243 I only had 10 ( on the left) that chambered ok out of this batch So I will take one of the ones that don’t and move it down 1/8 of a turn to see where it goes ( is that bumping the shoulder then? Thanks Jer

Sorry I just used to clean my 45-70 brass in my steel pin tumbler Let them dry Size them, trim if needed and then run them through my Dillon 550B After powder measure is set and my bullet seater and crimping die we’re set I could do 100 rounds in about an hour. I can’t even get two that work...

Run out on fired brass????

Ok I have tried new brass and they don’t chamber consistently. I can’t take the die apart. Not sure if that’s just because it’s RCBS or if it’s stuck and I didn’t want to wreck it. Shoulder bump. I am trying to get my head around this. Can you explain it please

Starline Brass out of the bag: ANSWERED I get one out of approximately every 6 or 7 of them that will allow me to chamber them????? Did I get a bad batch? But even after I resize and prime they don't load either ( just cases) RESISING DIE RCBS SETTING: Ran the ram up to the top.....screwed...