Search results

A friends weapon is grouping low and to the left by about 4". This is after sight adjustment has been maxed out. Until I actually shoot this .22 can't be certain. However, Are you aware of any aftermarket rear sights that would provide the needed adjustment? Thanks

Wanting it for the 150 ballistic tip. 24" barrel 7828SSC / H1000/ 7977 I thank you in advance

I have an American Defense QD mount for my fastfire 4. The screws supplied by Burris are .136 and the hole sin the base are .083. what size torque screws do I need ? Where can I get a few W/O crazt S/H cost? Thanks

The base screws provided with a True glow base for the 870 are too tight and wont work. I Dont want to force them of course. I realize that Remington goofed up when it was manufactured and/or the PRC made screws are out of spec. Regardless, what are my options in your experience? Thanks

Has anyone installed one in their shotgun ?

Comparing say Blitzking w/ Vmax, Ballistic tip . etc?

Rem. 12 gauge 1100 or 11-87. with vent rib and interchangeable choke.

Looking for 40 grain blitz king. open to others.....

Which Manufacturer/style do you find gives the most recoil absorption?

Got cut off on the tech line. Terrible customer service. Any help is appreciated. Thanks

Shot from Savage muzzleloader @ 2,400 FPS, went through 4 jugs. Retained 225 grains/ .769 " frontal area.

What loads pattern bet for you? Considering a box of Boss Toms https://bossshotshells.com/shotshells/tom-tungsten/

I wish to mount my Leupold/Gilmore red dot for turkey. It has a vent rib. Can be drilled and tapped of course. Any nice after market set ups out there that wont require drilling? Thanks

Most accurate Lyman Deerstalker .50 cal. flintlock loads. List them here:

I'm looking for the most explosive bullet for my .223. What has your experience shown you?

My Savage ML2 shoots .458 bullets in the harvester black sabot at 1" Velocity is 2,100 FPS. So what bonded 300 grainers/.458 Diam. are out there that will expand at impact velocities under 2,00 FPS?

I have a Lyman Deerstalker flintlock. As per state Regs, must have metallic sights. I like the williams fire sights but they dont make any for this rifle. Any suggestions?

https://nrawatch.org/filing/ny-ag-files ... nd-others/

I;m working up a load for my friend. I properly cleaned the the barrel. What is the proper inch pound torque for the front and rear stock screws? The middle screw I understand is to be barely tight.