NoslerCustom Rifle--possible debris in the bolt area?

Nosler4

Handloader
Apr 13, 2006
301
0
If it sounds like a small piece of debris floating around somewhere in the bolt area, or a wet chamber. Recommend the following clean & lube procedure:

-Remove the bolt assembly and clean the locking lug area in the receiver very well.
-Clean the chamber in the barrel very well – make sure it is dry.
-Remove the firing pin/spring assembly from the bolt body.
-Clean the inside of the bolt body, the outside of the firing pin, and the striker cam areas very well.
-Place a small amount of gun grease on the back of each locking lug, on the front of the firing pin shoulder, and on the tip of the striker where it rides on the cam surface.
-Re-assemble the gun and dry-fire it 4 or 5 times to move the grease around on the mating surfaces.
-When cleaning the rifle between firings, make sure the chamber is kept dry. Solvent or oil in the chamber will cause symptoms of high pressure.

This should correct the issue.
 
Back
Top