Inline Fabrication's case ejector and Unimount.

muleman

Handloader
May 12, 2009
1,380
55
Added these items to my Hornady Classic press the other day and finally put them to use this past weekend. I sized and deprimed 700 17Hornet cases in 1hr and 4minutes. The case ejector worked like a charm. I kept my right hand on the lever and fed the cases with my left. The ejector system worked great. It sped my time up by about 50%. It will work great with pistol thru short action cases. Right where you need high volume. Because you raise the ram before inserting the case into the shell holder you lose some clearance on the case. It'll work with full size cases just not as fast. Bullet seating may be difficult on any cartridge bigger than 3".
The Unimount is a neat addition to the bench. I raises the work surface closer to eye level and the bin system speeds up the process. A feature that's available but I didn't get was the quick change plate. It allows quick two bolt changes of presses and other tools. Check them out on line.

Scott
 

Attachments

  • IMG_0893.JPG
    IMG_0893.JPG
    1.7 MB · Views: 1,046
Back
Top