lanman
Beginner
- Dec 3, 2011
- 159
- 0
I've found myself shooting a lot of jugs as of late. I was placing them on a 3/4" sheet of plywood that I had laying around. The water displaced in the first couple jugs has destroyed the plywood. I found myself with some spare time at work tonight, so I scrounged up some scrap materials and built a rig to hold water jugs for bullet testing. I started with two pressure treated 4x4's that are 5' long. I put a layer of 1/2" plywood on BOTH sides to hold the posts together. I had a little bit of plywood left so I put short rails on the last 3 feet. I expect the exploding jugs would break 1/2" plywood rails next to the first 2-3 jugs. I measured a milk jug and found they are about 6" square, so I should be able to fit 10 jugs if necessary.
I made this in about 30 minutes out of scrap... I'm not sure how well it will work either. I'm curious, do any of you have a purpose built jug shooting table?
I made this in about 30 minutes out of scrap... I'm not sure how well it will work either. I'm curious, do any of you have a purpose built jug shooting table?