Need tool advice

What is the tool that you use to remove the cross bolt that goes across a Browning Safari and some Winchester bolt rifles, the "nut" has two pin holes in it. I assume you must hold that nut with some sort of tool to take that cross bolt out so you can remove the stock from these rifles.
Once I have it's name, where do I buy this tool?
Thanks

Maybe you are looking for a tool like this?

https://www.brownells.com/gunsmith-tool ... od416.aspx

Hope this helps ..

I've never tried it but a good quality snap ring plier should work, the cheap ones will probably bend but heavier ones shouldn't. you can pick them up at any hardware store. But again I've never tried.

Probably one of these? Post a picture of the fastener.

Or this one?

Buy this set. You’ll love it..

jezzolo":2e5u6pyi said:

Buy this set. You’ll love it..

Click to expand...

My wallet despises such posts. :lol:

Fantastic, thanks so much for your input.

Can get it from midway and here is a picture of the bit you need

Thanks, I ordered the Wheeler kit from midway, just fyi, all the Wheeler kits were on sale.

Keep me posted on how you like it,,, I love that set..