Greg Nolan
Handloader
- Nov 25, 2004
- 2,143
- 18
I've been seeing Banded E-Tips mentioned at SPS. Are they a solid or is the band a cannilure?
Banded E-Tips
- Thread starter Greg Nolan
- Start date
- Nov 4, 2004
- 24,414
- 6,794
The new E Tips has pressure relief bands cut into the shank of the bullet
to reduce bearing surface.
JD338
to reduce bearing surface.
JD338
nvbroncrider
Handloader
- Aug 20, 2011
- 3,085
- 3
Should in theory. Less contact less fouling.
Gunner46
Handloader
- Jan 12, 2015
- 483
- 3
Like a Barnes ?
Jimbeaux82
Handloader
- Jan 6, 2011
- 407
- 174
Same principle as Barnes TSX
- Oct 30, 2004
- 24,085
- 2,621
Well look at GS customs they worked the grooves in their original design. Gerard was a pioneer in this regard. Everyone copied his design in one way or another.
Gm weatherby man
Handloader
- Dec 19, 2010
- 287
- 0
If this is te case it will make them my favorite bullet, ill keep my eyes open for them 
- Oct 30, 2004
- 24,085
- 2,621
sbsmith":1zrrkmx8 said:
That would be blilliant :mrgreen:
Are we talking multiple grooves or just one big one?
I've got some with the single big groove. If I remember right they were located just a smidge below where the shank went to caliber width. So it seemed like there would be just enough rifling contact to nicely center the bullet and then a nice "relief" as the bullet would run up to full contact and pressure. One thing about multiple grooves is they raise heck w/BC. Even the super long Barnes lrx are pretty unimpressive in that area.
I've got some with the single big groove. If I remember right they were located just a smidge below where the shank went to caliber width. So it seemed like there would be just enough rifling contact to nicely center the bullet and then a nice "relief" as the bullet would run up to full contact and pressure. One thing about multiple grooves is they raise heck w/BC. Even the super long Barnes lrx are pretty unimpressive in that area.
