Recent content by BlaserR93

I had one in the 3-12x50 with 30mm tube.. I got it because it was on a Rifle I bought. I wouldn't let my worst enemy buy one...

7MM STW ALSO..

This is a must!!! Nosler definitely needs to look into producing this brass. Most venders are out of stock or only gets seasonal runs for Winchester or Remington and their qualities aren't nearly as good. Its a night and day difference. I just purchased eight boxes of 22-250 and 2 boxes of 7mm...

Very accurate, 1/2 inch at a 100. I haven't shot any farther with mine yet but plan to do so. I have a 7mm Rem Mag and a 375 H&H and both shoot under a 1/2 inch. Pull the barrel off and change caliber and always dead on.. They are expensive, but they are very nice rifles...

I have a Blaser, and was skeptical at first also.. I have always been a Remington man until I witnessed the Blaser at the range. These rifles are very different with the straight action and the option to switch barrels and calibers...These rifles are very accurate due to the design, all barrels...

bump ^

Nosler, How about some reloading info on this new hot cartridge?

Any results in your load in your 375RUM?

How about any load info with the 140 accubond?

I made sure the action/bolt was completely slammed forward. That couldn't have been the problem. Do you shoot reloads in yours? I contacted Blaser and they immediatly sent me a call tag to send it into them. My rifle is in 7mm Rem Mag and I loaded some Accubonds in 140 grain with 65.5gr of Rl22...

Does anyone use this rifle here on the forum and have you had any misfires?

If so, where did you start out, What kind of seating depths and how hot are you loading for a all around Hunting load?