Recent content by BossGobbler

That is an impressive 3 shot 200 yd grouping. Very nice!

Thanks for the detailed information. Never heard about Tubbs bullets. I checked out the website. I will purchase a set. Did you notice accuracy change with loads you had before using Tubbs or just velocity changes?

Thanks for the detailed info. Would you tell me more about Tubbs bullets. I checked out the website seems interesting.

I want to hunt Nilgai in the next couple years. It sounds like you have done it quite a bit. Would be so kind as to recommend a place to hunt?

I have a Redding dial comparator and fired cases from this gun will typically range from +0.0004 to +0.006 above Sammi reference case. I don't know if this is normal or small. I can say my wife's Browning 300 WSM is .002 shorter by comparison. Do you think the seating depth is causing the...

Thanks for the response. As noted, I did check the data on Barnes's website beforehand for this combo. As to why start where I did, I wanted the hardest hitting accurate load and I had been told by another that somewhere near max is usually the 'best' load. So, I don't want to waste time...

I have a question for those with more knowledge and experience than I do. Some background is that I used to use only factory Fed 165 Trophy bonded tip or Vortx 165 gr Barnes because it shot 3/4 MOA using those and I didn't reload. Occassionally I would find that some rounds would stick the...

Thank you DrMike. I must say you are quick on the reply!

After searching all the vast 300 WSM threads on here and looking at my own sources without success, I figure I might as well ask for some load data. I have been unable to find load data for RL 19 and 165 TSX for a Browning Xbolt 300 WSM. If someone could help out that would be greatly...

df DrMike, did you happen to find a QL for the .300 WinMag using Reloader19 or should I consider searching for a different powder. None of my reloading books show Reloader 19 as a propellant using a 200gr bullet. I typically only shoot WSM but just got a .300 Christenson MPR and want to...

Good to know. Thanks DrMike

Thank you Drs. Mike and Vette!

Good Morning. I’m loading for a new 300WSM. I have a great load for my Win model 70 WSM using 165gr Barnes TSX and 59.0 gr of Accurate 2520 COLA 2.850 FED 2015 primer. However, I have a new Fierce .300 WSM and want to to load 200gr ELDX. I have Accurate 2520, Accurate No. 9, and...