Bruce Mc's latest activity
-
Bruce Mc replied to the thread Chronograph comparison.Don't forget that the doppler radar is going to slightly undervalue the velocity due to its angle from the bore line. 5 degrees amounts... -
My light shooting chrony likes to be set up in shade to keep from getting missed shots but it has been very accurate when I do. One of...
-
When I first got my Garmin chronograph, I compared the velocities recorded by both the Garmin and my Competition Electronics ProChrony...
-
Pretty consistent better the two chronographs. May try seating three .005" deeper and another three .010" deeper. JD338
-
As it is, the numbers matter less than the accuracy so I'd say your load is pretty/very good (y)
-
Bruce Mc replied to the thread Chronograph comparison.Yep, no missed shot, much less set up time and effort, more room in the gear box minus the tripod.
-
I use the Tipton vise for mounting scopes with no problems. I also use the Wheeler Leveling System...
-
Going out to the range tomorrow with a 375 BAS. I decided it's time to start playing with her again. The cartridge to the right is the...
-
Bruce Mc replied to the thread Chronograph comparison.The loads shoots consistently at 3/4". I did have one group that shot 1/2". I'm happy with the load but now I'm obsessing over...
-
Last year I worked up a 270 win load of 62.0 gr of Ramshot Grand and a 150 gr Partition, Nosler case and Federal magnum primer. It shot...
-
New photo of my grizzly skull and a 30-06 with the 200 grain Nosler Partition loaded to 2600 fps. Heck of a hunt. Sometimes it's hard to...
-
I've got a mess of those I bought from SPS years ago and haven't made sufficient use of them yet... Based on what the 115's have done...
-
Bruce Mc replied to the thread Straight Wall Wildcat.How about something like a longer version of the old 44 auto mag.
-
Bruce Mc replied to the thread 7mmRM 175 Part Grand.A 115 partition in my 25-06 is my next project with grand.
-
Bruce Mc replied to the thread 7mmRM 175 Part Grand.I sure wish the Ramshot Grand profile was available in quick load. I'd like to see the pressure estimates on these loads.
