Recent content by DarkMoose

Someone know when Nosler plan to release the new handbook ?

I already have a lot of h1000 powder for my 300 wm and I'll start reloading 7mmRM for my brother in law this fall. So I don't want to purchase another powder for someone who shoot less than 20 round a year. Our bullet of choice is the Accubond so in his case we will load 160gr bullet in Nosler...

My last test with near SAAMY COAL wasn't a suscess. So I decide to go with another bullet. I get a lot of testimony of similar trouble with ABLR, really finiky in some rifle. I'll start reload the AB200 tomorrow and test it this weekend

I hope this was only this

I will test it at 3.4 .... come back later

I inspect my steam to be sure it dont it the tip when seating and everything is fine... this is what you talking about ?

I load 5 3.4 ... this will be my last test, if the result won't get better consideraly, I'll forget the ABLR

Rifling 3.605 Mag 3.59 Tested load length 3.585

Your ABLR 190... what are your COL ???

Probably. But I will try my ABLR at 3.40 (.06 than SAAMI) first if the result wont go really better, I'll start develop for the 200 standars

My first concern at the beginning was my 1:8 twist, I was affraid of some tell about overspin issue.

just surprise a lighter bullet need less powder than an heavier one. The 210 are 75 to 79...

Now I hesitate between still work this bullet or go back with a standars Accubond. Hunting season here is at the end of september.... time begin to miss

yes 2840 and 2860 sorry for the typo... This was with 2 different load... 77.8 and 78 same POI the 2 load, but each with a really bad flyers...

Can't see something on the Nosler book, and Hodgdon website seen really low. Can someone have a good starting load and max load for it. Thank you ? 300 wm