Joe C.'s latest activity
-
When I had my 270wsm it shot 130g Etips over RL26 best. -
I am going to have to look closer at Re-26 for the 270 WSM with the 140 gr AB, 140 gr Trophy Bonded Tip and 136 gr Terminal Ascent...
-
Joe C. replied to the thread Reloading 270 WSM.Unfortunately Magpro is one that I dont have around
-
Joe C. replied to the thread Reloading 270 WSM.I'm starting ladders for two loads for this weekend. 1. 270 WSM, 145GR eldx, with RL26 2. Is the 130gr E-Tip, with Staball HD. 3 130gr...
-
Joe C. replied to the thread Reloading 270 WSM.I’ll figure it out. As far as suitable powders on hand go it’s Staball 6.6, IMR4831, IMR7828SSC, RL22, RL23, RL25, RL26, Staball HD. So...
-
Joe i worked up a load for a friends 270 wsm. It relly liked Magpro.
-
Joe C. replied to the thread Speer 168gn Gold Dot in 300 WSM.I really like the 150gr GD’s in my 308 Win. Great deer bullet. They hold together great and are very consistent. Speer did have troubles...
-
Joe C. replied to the thread Reloading 270 WSM.Thanks Mike for the input. My RL23 load with Partitions is great. It’s an upper load I think, as it has 66gr of RL23 and a 130gr...
-
The WSM cartridges are not overly sensitive. I treat them as I would any longer cartridge.
-
I have not handloaded for my current rifle (LH Browning X Bolt All Weather 23" barrel) in 270 WSM as yet. The factory ammo tried to date...
-
Joe C. replied to the thread Reloading 270 WSM.Thanks for the response. My next step was going to get a Forster Go/No Go gauge, because the chamber feels snug when closing. What’s on...
-
Just asking those that have worked with them. Are they super sensitive to pressure? I know you have to keep an eye on it no matter the...
-
Joe C. reacted to 300WSM's post in the thread 2023 Burn Rate Chart (Updated to current Hodgdon chart) with
Like.
to a point it does but burn rate is still burn rate. We have charts that vary but the variances are slight...and that's probably some... -
Joe C. replied to the thread 25 WBY RPM Dies.Send a few fired cases to Redding. They will hook you right up. I think dies will be offered if the round builds a following.
-
Joe C. replied to the thread RL19 in 270 Win.Never used RL19 but its in Noslers load data for 140 grain loads.
