Recent content by loganht1

Have you ran the math / software / calculations for chamber pressures and muzzle velocity? Or chronographed this load? I didn't se your earlier thread. Sent from my SM-G950U1 using Tapatalk

Hmmm. As 47 year resident, I still can't pick out all the different mountain ranges at a glance. But I'll bite and guess the "Crazies". My two adult sons and I couldn't coordinate the time off until Nov.1st but as soon as all my little grand spooks are put to bed on Halloween . We will be out...

FWIW. From a Montana man like me. :-) I would call the Sharps people in Belgrade, MT and ask them what they know about the cartrage. I'm sure they would be happy to visit with you for a few minutes. Sent from my SM-G925V using Tapatalk

I have experienced this issue. The brass can be resized and reused. Even reused in a factory chamber. However your gun will always "Mark / Personalize " it's brass. Enjoy the gun . It is safe. Sent from my SM-G925V using Tapatalk

The ring is caused because the Smith did NOT shorten the threaded end of the barrel and then add additional thread. ( more work). The shoulder of a 308win is wider at that point than the brass on the 30-06. That was done intentionally durring 308 cartridge development so the 308 can't be...

Several years ago I tried some RL17 behind 210grs in my 338wm on a warm day in June and experienced the same issues. Chronograph 3100+ , kicked like 250s, and hard bolt release. Gave up that idea. Currently have great results with H4831sc. Behind Sierra and hornady 225s in both of my 338wm...