nosler06's latest activity

  • nosler06
    nosler06 reacted to phil's post in the thread Primer Question? with Like Like.
    It can be a vast difference, depending on what it prefers. Drop down a couple grains and do another charge weight test. Sometimes it can...
  • nosler06
    nosler06 posted the thread Primer Question? in Reloading.
    I'm looking for any wisdom from the experience knowledge that's out there. Currently I have switch to 165gr Nosler Partitions in my...
  • nosler06
    nosler06 reacted to sako2's post in the thread Primer Question with Like Like.
    If they were resized but not enough they won't be that hard to size. Spray some lube on a towel and wipe it on.
  • nosler06
    nosler06 reacted to jimbires's post in the thread Primer Question with Like Like.
    most reloading lubes are primer / powder friendly . it says on the spray can ; one shot case lube will not contaminate powder or...
  • nosler06
    nosler06 reacted to Heavy Barrel's post in the thread Primer Question with Like Like.
    Depending on the cartridge you’re working with and how much you’re willing to spend, Redding makes body dies for bottleneck cartridges...
  • nosler06
    nosler06 reacted to RiverRider's post in the thread Primer Question with Like Like.
    I do not recall where or when---it's been quite a few years---but I recall a article written by a reputable gun guy about the...
  • nosler06
    nosler06 replied to the thread Primer Question.
    So I use Hornady One Shot as case lube. I'm assuming that this spray will def be bad for primers so im guessing that I will scrap all of...
  • nosler06
    nosler06 reacted to wvbuckbuster's post in the thread Primer Question with Like Like.
    Not being cheap just practical.
  • nosler06
    nosler06 reacted to jimbires's post in the thread Primer Question with Like Like.
    you can call me cheap , I reused them at $9 per thousand . :)
  • nosler06
    nosler06 reacted to michsteve's post in the thread Primer Question with Like Like.
    I was about to say the same in fact I use the Harvey deprimer tool, all my sizing dies I have removed the depriming pins.
  • nosler06
    nosler06 reacted to Charlie-NY's post in the thread Primer Question with Like Like.
    I have removed primers on a few occasions. I used to just toss them because primers were $25/1,000. Now that they are $125/1,000, I save...
  • nosler06
    nosler06 reacted to Hunter26's post in the thread Primer Question with Like Like.
    I haven't done it often, but have removed live primers very carefully and reused them without issue. Not sure I'd use them for anything...
  • nosler06
    nosler06 reacted to jimbires's post in the thread Primer Question with Like Like.
    ** always remove live primers before annealing ** I remove the decapping pin in instances that I forgot to resize the brass . if...
  • nosler06
    nosler06 reacted to RL338's post in the thread Primer Question with Like Like.
    If you lend up nocking the primers out just toss them. They don’t spring back when removed and they won’t be as snug if you reseat them.
  • nosler06
    nosler06 reacted to JD338's post in the thread How accurate can a RCBS 10-10 scale be? with Like Like.
    You have a really nice set up! The only issue I see is that your reloading shop is too clean.😁 JD338
Show older items
AMMUNITIONAmmunition BULLETSBullets BRASSBrass FirearmsFirearms GearGear
Back
Top