TackDriver284's latest activity
-
TTackDriver284 replied to the thread Cylinder Honing.Not too sure on this, but just a thought. If using very fine 1000 / 3000 sandpaper wrapped on an undersized bronze brush and wet hone it...
-
TWether it’s a light cast load or a full load of H110 and 240s they all stick. I’ve learned to deal with it but I’m looking to see if I...
-
TI got a hone and was going to give it a try this weekend. Just looking to get the empties to drop out a little easier.
-
TThe cylinder on my Tracker is anything but perfect. Nocking the empties out is a PITA. I’m looking at using a Flex Hone for firearms for...
-
TTackDriver284 replied to the thread Cylinder Honing.Are those casings getting a little sticky in the cylinders? I recall pushing loads with the .41 Magnum until it was a bit sticky using...
-
TTackDriver284 replied to the thread Red Dot?.Send 2 lbs of Blue Dot my way, hard to find those powders I used for my .38 Super years ago. :D Currently replaced Blue Dot with Power...
-
TTackDriver284 replied to the thread Pulling factory bullets and replacing.I could choose both options, shoot all the ammo and have it fireformed in one go, then anneal, resize it and tune up a few loads to see...
