Recent content by Tog

That is impressive.

With 1.8 grains capacity difference on a case that large, I would think lot to lot powder variations would have a bigger impact. Why? Varget, it was a learning experience.

Ordered the Lapua, thanks.

It is funny because it is true!

All 1-9"s are not created equal, you will have to experiment to figure out your barrel. I have had barrels (16" AR) that would put them point on at 100, but never tried them any further out. My CZ 527 Varmint refused to keep them on the same page. 69 grain Custom Competitions, SMKs, and TMKs...

I have to admit the Norma brass I have been loading in the 22-250 has made a very good impression on me so far.

For some reason, I cannot currently upload pics of these bullets, despite my efforts. ...I will try again. I am amazed that the impressive collective mind of this website knows nothing about these bullets. Then again, emails to Nosler have yielded nothing. I have skimmed about 600 pages of this...

Topic says it all. 26" Shilen Barrel, which brass should I choose?

I do not believe there is a direct correlation between reduced velocity and accuracy. A number of competitive sports are pushing things hard. Do not try this at home. Look at F-TR loads in 223 with 90 grain bullets. These are 30" barrels with .169"+ freebore, 2.5"+ OALs, and scary pressures...

As some have said, the better the brass you buy, the less important it is to sort. I wish I had started buying Lapua much earlier and wasted less time trying to turn cheap brass into something it wasn't.

Part # VG6216 Anyone ever seen, heard of, or tried these thing? Sold as blems through SPS, I ordered them in Oct, 2015 and just getting around to using them. Searching the internet yields nothing. The accuracy load for the 62 gr Varmegeddon from Nosler's data does well at ~0.6MOA (22.5 gr...