Hey Scotty I've sent you a few pm's not sure they are getting through. They are not showing up in my sent messages
Sent from my SM-G975U using Tapatalk
7,300 square feet of house and 4,000 square feet of deck. It felt like a never ending stack of windows. You should see the kitchens. Yes 2 kitchens. 7 bathrooms 7 bedrooms. Every bedroom had its own bath except the 2 in basement. Ill see if I can dig up some more pics. Me and 4 other guys built...
Yes its faced insulation. Yea its kinda fun but I do this stuff everyday at work. I could have built this shed for almost 1500 cheaper but I don't have time. I ordered it and it was on my prepared site in just over a month. Can't beat that. [emoji2962]
Sent from my SM-G975U using Tapatalk
So I got enough of the honey do list done yesterday to work on my reloading closet. Its not very big but I think it will work fine. Just hope I can get the temp where I need it so I don't have any issues. Its 6' x4'6"x7'. R13 insulation walls and ceiling. Floor is already insulated. I'm just...
I installed my press on the inline fabrication tall press stand i have. Placed it on my kitchen counter which is 36" tall. It seemed to be very comfortable standing or sitting on my bar stool that I use in my bow shop. That bench is lower but I Stand and work there. Its shorter but not much...
So I've been working my old brain. Trying to figure this situation out. I was enclosing my reloading area anyway in the back right corner of the shed so no dirt and crap can contaminated the area. If I place a small electric baseboard heater in the enclosed insulated area. Keep it at let's say...
I live in the Catskill Mts of New York so its cold. Looks like I'll be doing the shed up before doing any reloading
Sent from my SM-G975U using Tapatalk
I am putting my reloading station in a non climate controlled shed. Well its not yet will be insulated and heated but not this winter. Will the cold then turning a heater on when I'm in there affect tools, powder and such. Condensation would probably be an enemy i would think.
Let me know...
Yea I'm pretty sure I didn't need a lot of this stuff I got to get started(dont tell Momma) but I go all in when I'm doing something. My shed was for working on my wheelers but now I have to make room for this. I'm thinking of a 4' to 6' bench with doors that close around it to keep dirt and...
7mm08 to start. Then my son has a 243 that I might try. I've made him save all his brass for the last 2 years. OCD, psychotic anal, perfectionist all of the above for me. I'm in construction if you start right it ends right. For me rough framing is finish framing.
Sent from my SM-G975U using...
Ok i believe it will be easier to type what I don't have already or whats on the way. I'm hoping some checks will clear the bank Monday and I will be getting these things. Case cleaning stuff. I'm going to go with wet cleaning with stainless steel media. Case trimmer. I've researched a few and...
I have a few things already. Press got here Thursday. Everything on your list has been ordered [emoji809] more things. I've jumped in with both feet well it co6t me both feet and an arm and a half just for 1000 primers. Lol
I've been going through the hornady hand book to get myself hooked...
I have put out a few to you all already and have gotten excellent advise. I check out the videos in the morning with my coffee. Thank you
Sent from my SM-G975U using Tapatalk