Search results

Here is the 30-30 head stamp along with the one 32-40 piece of brass. 300 H&H with various 7and8mm Mauser . I think the short 30-30 is non fireformed 30 herret

good afternoon, I won an auction of brass. I’m cleaning it up and then sorting out. I took a chance and it and pretty much need none of it. There were 20 pieces of 308 fireformed to basically straight except the mouth which looks like it had a crimp on it. I’m assuming it was done in a chamber...

I have noticed on my 9mm pcc and 300 BO that the first couple of rings are must slower reading on my garmin. I know of first round pop but I will load a few rounds then take outside to test but realizing that’s not good if I’m getting 120 fps difference. Has anyone here experienced that. It’s...

Does any one have any experience with making subsonic 147 xtp loads for a 16” barrel. I tried 4.2, 4.4 and 4.6 grains of true blue. Loaded to 1.1” oal. The 4.6 load was the only one that was consistent. I thought it was a clean powder but brass is fairly dirty after being shot. Almost like there...

Does any one use this puller? How does it work as in good or bad not actual operation. I have an entire ammo box of military 300 mag. Loaded too long and too hot. Started pulling bullets but kinetic bullet puller work good but I’ll be retired in a couple years before I finish

I’ve always been more of a shooter than a hunter. The 6.5 creedmoor is a nice round. I’ve been more partial to the 6.5x55 since I like Milsurps. The creedmoor just seems to shoot well pretty easily. Any way a couple of guys have been shooting heavier bullets at least for the creedmoor like the...

I have a t/c contender carbine barrel in 7mm tcu. I’ve not gotten it to shoot well. Finally have headspace and ogive comparators and the 7mm bullets I bought are ppu. When I started checking loaded rounds I found the only real differences to be base to give but oal was in .001 to .003...