Search results

I shot an OCW test and am having troubles determining the sweet spot here. I used OnTarget software to find the POI for each load. I have an idea of which load to try next but want to get some folks' opinions first. Below are the specs of this gun/load Gun: Tikka 30-06 Bullet: 180 AB Powder...

I’m contemplating buying a box of ABLRs to try in my ‘06. I have H4350 on hand that I’d like to try first. Anyone have any experience shooting this bullet in their ‘06? Sent from my iPhone using Tapatalk

I shot a ladder Test and found 57 grains of h4350 with a 180 AB to be in a node. I shot two separate three shot groups at ~100 yards. They both produced near identical patterns. Two touching and one flyer about an inch away. All the shots felt good, no pulled shots. I'm puzzled as to why this...

I can't find any h4350 for my 243 and 30-06. Anyone else been able to find it? I'm worried it may be a while before it comes in stock again. Anyone have any alternative powders they like in the 4350 range? I was thinking RL17 but worried about temp sensitivity.. Thoughts? Sent from my iPhone...

I haven't tested this but am curious if anyone else has. Can the optimal seating depth change if you change powders? I have some leftover RL22 and was considering using it to do a seating depth test after doing some load development with H4350. Sent from my iPhone using Tapatalk

Did a ladder Test with 70gr varmageddon and H4350 today. Started at book min of 42gr and went up .3 increments to 47gr. Didn't see any pressure signs with my last shot but not comfortable going more than a grain higher than book max. Test was done at 350 yards and had a 5-7mph wind from my...

Could someone run a quickload for me? Working on a load for a 243 I just bought. 70gr nosler varmageddon .334 BC H4350 COL 2.680" 22in barrel Nor sure what my actual case capacity is. Nosler book says 50.8gr Also, would be interested in anyone's experience with this bullet. Thanks in...

I've been shooting some factory loads of Winchester and Remington thru my 30-06. I'm starting to accumulate some brass from each and have been using both in working up a couple loads. I'm looking to move to one brand of brass to get more consistency in my load development. Here are my 3 options...

Hi all, Does anyone have any experience loading the ABLR in a 30-06? I found a good deal for some 190s and am debating trying them out. I'm a little worried about my gun being able to stabilize that heavy of a bullet. I have a 1 in 11 inch twist barrel which is the minimum recommended per...

Looking for some 30 cal bullets for my 30-06. Looking for the below types but may be open to other offers. Strictly nosler though. - 190 ABLR - 180/165 partitions - 180/165 accubond - 168 etip Thanks Sent from my iPhone using Tapatalk

Hi guys/gals, I'm working up a load in my 30-06 for a 168gr nosler CC. I'm using RL22 and per the nosler load data started at the lowest charge at 59gr. I loaded 5 cartridges in half grain increments to 61gr. No pressure signs that I could tell except for maybe this. Is this a sign of pressure...