Nosler load data shows the most accurate powder as h4831sc. I have regular h4831. Would you expect that I could get close to stuffing a max load of 60.5 grains (97% load density) into nosler cases without the sc version? I would certainly start lower and work up but don’t want to waste time with this powder if I would be limiting myself too much below that load. I know I could just try it and see, but was hoping for advice from someone with experience using these two powders. Any thoughts would be appreciated. Thanks
280ai with 150 ablr and h4831
- Thread starter Nealc
- Start date
I don't see a problem at 97% fill . I'd use a drop tube funnel , it will help settle the powder in the case as you pour it in . I'm pretty sure the nosler book uses what's known as ; usable case capacity . this is the usable capacity with the seated bullet being considered .
the two powders you mention are the same . the "SC" version is just " short cut " these should use identical load data .
the two powders you mention are the same . the "SC" version is just " short cut " these should use identical load data .
DrMike
Ballistician
- Nov 8, 2006
- 38,131
- 8,165
I load a number of cartridges to 110% fill. My max for loading is 114% fill. You should have no difficulty, as Jim states.
- Thread starter
- #4
- Nov 4, 2004
- 26,834
- 12,952
I agree with the others, just use a drop tube.
The 150 gr ABLR is excellent in the 280 AI. It flattens deer in their tracks.
JD338
The 150 gr ABLR is excellent in the 280 AI. It flattens deer in their tracks.
JD338
