Recent content by hseII

H380 is the next slowest powder adjacent to LVR on the burn rate chart, but I don’t recall seeing any 6 ARC loads using H380. I’ve got some of that as well so I’ll give that one a go. Thank You All.

Thank You. I’ve got the Hornady app but I was hoping that folks had been loading the NBTs on here & had info to share. I guess this is not a normal load.

What’s your loads for those? Maybe I should rename this thread the general ARC load?

My details are as follows- 22” Rainer Hornady brass currently. Just ordered ALPHA brass. LVR CFE223 VARGET

Quite a few loads for the 6 ARC bolt guns but I haven’t seen as much on a gas gun in this weight. I would like to see if there is an advantage pushing the lighter bullets faster at this pressure level. Please share favorable 6 ARC loads for a Gas gun shooting the 90-95 grain projectile. I...

Please share your results.

They are “attention getting” in a SP101 short barrel too. Sent from my iPhone using Tapatalk Pro

This. All day long. Sent from my iPhone using Tapatalk Pro

180 Accubonds in the WSM. 200 Accubonds in the WM. Either of those going in the ~2,900fps will kill anything big enough to die for a long ethical distance. H4350 for the WSM H1000 for the WM. Sent from my iPhone using Tapatalk Pro

I’m On the lower side of the 49 & I believe I need to get on that list too! Sent from my iPhone using Tapatalk Pro

140 Accubonds should lend well to the longer throat. Sent from my iPhone using Tapatalk Pro

The .260 Remington does it for me. ~10 grains less powder than my old .270 Winchester shooting 140 grain accubonds & I’m getting within 100 FPS. Sent from my iPhone using Tapatalk Pro

Awesome! Please share your Experience. Sent from my iPhone using Tapatalk Pro

Have you looked at PRS? You seem to be too well to just hang up competing. Sent from my iPhone using Tapatalk Pro

I always had super performance from the Winchester black box 140 Accubonds. Replicating that load would be my recommendation. Sent from my iPhone using Tapatalk Pro