Recent content by jerbearyukon44

No that scratching was from pulling the bullets on the ones that wouldn’t load. I just wanted to reuse them. I made up a bullet that would load and covered it in black felt pen… I ran it in and the darn thing loaded perfect. So I did another one and am letting it dry. Go figure. I have it...

IMR and H4350 for sure Going to load IMR for now and I can play around later but I need a few round for gun season first. Wanna take a deer and bear with it just to see how it performs. I will go after deer and elk with the bow on Sunday morning….😁

I think either the IMR or the H 4350 could work

So my results and I am going to load up 3-39.5 IMR 4350 and 3-h4350 just to see

Those are nice bucks bud

So I have 5 - 39.5 and 4 - 40.5 grainers for my 100 grain Nosler partitions One to warm the barrel up and to get me into shooting mode. All chamber. Thinking a bad batch of Starline now cause the measurements are just about identical ( big mystery). Anyway thanks for all your help team and...

I can sure see the need for two calipers though 😳

PS ogive is 2.24” and jam is 2.2775”

Ok I have success with my first Hornady bullet 😁😁😁😁😁👍👍👍👍👍👍. I took my time and used the Hornady wax These are my measurements before with a case out of the box. Then sized, trimmed, seated. 39.5 grains of IMR 4350 Going to load 4 of each 39.5-40.5-41.5-42 Based on newer load data someone...

Sorry when you lose your confidence and don’t know why things are happening this way it’s a problem getting it back. Just want this to work this time Cost me another 170 bucks for new brass and die set just because of what’s happened in the last batch. Plus wasted materials

Sorry but now I am really losing it. Feels like I have never loaded a case in my life but this has got me spooked so I am questioning everything now. So I measured the C.L. ( case length ) of all the Hornady brass BEFORE I run them through the sizing die. SEE PIC Most are around 2.039 and...

This was the group of 50… it’s a lot of levering but thought I would start with the basics Can you chamber the NEW BRASS 😳

Just chambered all 50 rounds of Hornady and they all worked smooth as butter. Wondering if I got a real bad batch of Starline brass Will contact them tomorrow

So I used the headspace gauge on 3 ( right out of the box Hornady’s that chamber) and they were within .0001 of the original. Then the new Starline is .00065 more😩 The one on the left is the Starline case straight out of the bag.

Waiting to dry so I can finish marking the rest