phil's latest activity
-
phil replied to the thread Peterson Brass Info.That company is getting with the program…good stuff.👍 -
phil replied to the thread 129gn ABLR.Sounds like it’s just right for behind the shoulder.?!
-
phil replied to the thread 129gn ABLR.I’ve been considering running these in my 6.5 Mega, or the 142gr. Or the 130gr AB.
-
phil replied to the thread Peterson 280 AI Brass.Tough and consistent brass, in my experience. I’ve used quite a bit of 280AI.
-
phil replied to the thread Nosler 28 Muzzle Break or Can?.They are so very convenient, in every way.
-
That is interesting. I had tried to use the ABLR long ago for a rifle and it was so fussy to find the accuracy I wanted but gave up on...
-
phil replied to the thread .264 130/140 AB.Just used for hunting, you don’t really need many bullets for a hunting season. There certainly are easier and cheaper selections for...
-
phil replied to the thread Nosler 28 Reloading.I don’t have IMR 4831 anymore
-
phil replied to the thread Die to press alignment.If you have a doubt get one chucked up and put a needle on it. If it’s reamed straight….i guess that would eliminate one thing. I’m sure...
-
May have missed it...but do not recall seeing the Nosler 2026 Wish List thread yet... Still on my recurring Wish List: 260 gr 41 cal...
-
phil replied to the thread Anyone have load recipe for fire forming 264 Win Mag with faster powder?.One way to do this is to seat the bullet jammed a little, .010-.015” or so, with a REDUCED powder charge. Your case belt would still...
-
Die to press alignment is not usually an issue, but die to case alignment is: Aligning your F/L die to case is not so difficult...
-
phil replied to the thread Die to press alignment.The last Redding seater I had caused excessive runout. For me anything over .001 is alarming, personally.. I use a an LE Wilson for that...
-
phil replied to the thread Die to press alignment.That’s one thing I like about 21st century Mandrels/Dies. They can self align.
-
phil replied to the thread Die to press alignment.Never dealt with this myself, but is there a way to orient the shell holder to allow for self-adjustment of the case as it’s pressed in...
