Recent content by TexasLife

ql is foreign owned iirc. it was the only place to find data on 277fury (80k, 65k), 22 & 25creed and a few others.

i have a subscription for it, but haven't tested any of their data.

i plan on getting a mrad and do a 4 nosler cartridge builds. 1 mrad with 4 barrels 26 27 28 30 might swap the 26 for a 33? before i do so i'll have to buy some mags to find out what max cartridge lengths could be. what i want too do is buy maybe 4 mrad's and set them up for this way. 4...

that seems very mild for that bullet in a 28n?

they should take the g21/41 mags that hold 13 rounds standard amount for full sized. for the 10 round state mag limit i don't know if glock makes a 10 round full sizes being in Texas i don't research mag limits.

i hadn't seen a trailer designed that way except for a semi trailer that had a center entrance/exit.

head to head as in a slant

engine tolerances are tighter and still have the dipstick. transmissions will leak via cooler lines and rear seals (yokes), so there's a very good reason to keep them! auto makers are getting closer and closer to where they control everything and can only be worked on by dealers as the codes...

i find n560 a god substitute for rl22

we weren't big game hunters, but did our share of keeping quail and turkey in check! my .410 single shot did lots of damage. what we killed we had to clean............quail; was quick and easy, but turkeys took time..................we had a 15 gallon bucket and filled about half way with...

with no chrono at the time and no issues on extractions or case/primer problems the 1st time i went beyond published data was when i 1st started reloading. i still use that same load today as i did back 41 years ago with sierra 140sbt's, imr4831 @ 61.3grs. 1 day i'll chrono some. that load...

sounds like it's gtg! what's barrel length for this setup?

on another forum a member said it looked like termites got a hold of it :ROFLMAO: . how about this 1............g20c gen3

i jumped on the 45-70 bandwagon with another purchase in this cartridge. decided to try a takedown.

yes, i'm installing a mrds. it came with 3 plates (dpp, rmr, rmsc), but the sro and rmr-hd won't fit..............i had to order another plate. mightput the arco on it, but unsure at this time?