Search results

Thank you, I should have mine ready next week cant wait to try it out. Elmer

Thank you Dr Mike! Elmer

What loads are you using and what speeds are you getting with the vlds and RL-26? Thank you Elmer

Hi looking for some on a few powders I would like to try in my 6.5 SAUM. 24" barrlel COL:2910" 140 berger hybryd I would like to see the results of Vihtavouri N165, Imr7977, RL26, H1000 Thank you to anyone that can post some info on this caliber. Elmerdeer

Thank you! Elmerdeer

Hi guys can anyone run QL for me on my 2 pet loads for my 280AI 1)COL: 3.435, Berger Hunting vld 168grs, cci br primer, Vihtavouri N165, Nosler brass. 2)COL: 3.430. Hornady 162gr Amax, CCI Mag primer, Vihtavouri N165, Nosler brass. My barrel is 24" long. I am running the Bergers at 62grs and...

Thx JD338 I will post my results when I shoot the 180's. Elmer

Hi guys I am getting my Win M70 280AI custum back from the gunsmith this week and would like to try the 180gr bergers. Has anyone found any good loads with this combo? My barrel is a Krieger FW contour with a 1-9.5 twist finished at 24", and the powders I have on hand are H4831,Rl-22, Rl-25...

Has anyone used this powder in the 7mm Dakota with 180 bergers or the 168 bergers? How was your speed and accuracy? And what were your startiing loads? Thanks Elmer

Update, i could'nt resist I took a hammer to the primers that did not go off and gues what the went bang! I geuse its a firing pin issue and not the primers. Elmer

Well I checked the firing pin, I checked to see if trigger sear was slowing down the firng pin,and i also checked the depth my pockets in all my brassfired and new everything is the same, so then ,I thouhgt i had seated them to deep but I seated some in new brass and chambered and fired five...

Yes they are new, about 1 year old from the time I bought them. Thanks Elmer

Ok here goes my primer pockets are .1285-.1305" deep from same lot of brass measured with a caliper, and the primers that didnt go off were saeted .009-.010" deep from flush, is that the correct depth? i think I seated them to the bottom as I always squeeze my hand primer twice and rotate...

I have the data, I was just being cautious. Thank you for your help! Elmer

Here is the problem I ran acroos today, I have 2 times fierd brass that was going on 3rd firing today, they were PFL resized. This brass fired some loads that had pressure signs, Ex:extracter marks and slightly sticky bolt once in a while. I did back down from those loads some. So here is what...

Hi does anyone have any loads for the 7mm Dakota using 175 sierra game kings? I have Imr 7828, Retumbo, RL-25, Rl-22, on hand. Thanks Elmer

I have a stiller predator action, Caliber is 7mm dakota, barrel length 24.5", my COL 3.495" with the 180 bergers. Can you please get me max loads and pressures with the different powders on QL? Thank you Pop! Elmer deer

Thanks Pop. Elmer

Hi guys my custom 7mm Dakota is arriving in a week and I need some good loads preferably with heavier bullets 160grs and up? And if you guys have the velocities can please post them. Thank you elmer

What is the best carbon cleaner you guys use? THx Elmer