Search results

After receiving the gun back from the gunsmith with an assurance the chamber was fine and the headspace was ok. I checked the chamber neck depth (2.632"), brass length @2.569". This is where it gets embarrassing......when I was cleaning the barrel, I noticed the brush felt very tight for about...

Something else to add to the list to check. Thank you. Sent from my SM-G900V using Tapatalk

I have already asked him to do that. Thank you Sent from my SM-G900V using Tapatalk

I haven't measured. However, I don't experience any difficulty chambering rnds. Sent from my SM-G900V using Tapatalk

I'm not sure. I have trimmed them to 2.569". Also have ordered a chamber length gauge. Sent from my SM-G900V using Tapatalk

Build up where? Sent from my SM-G900V using Tapatalk

I thank y'all for you advice! I will put it all into the mix for the future when I get my gun back. Thanks again!

I started out using 869 and 50BMG with 129 ABLRs. No pressure problems, jus 2+ MOA groups. At around 70 rnds through the gun I switched to 140 Gr AB and 869. No pressure problems until around 150 rnds and going to RL-33 and RL-50.

Thanks, my gun is still with the gunsmith. I will ask him to check that too.

Thank you very much!!

When I measure the powder I use a trickler after getting close to the desired weight. I check calibration of both the electronic scale and the balance beam.

The fired cases slip down over a bullet. My chrono is back at manufacturer being calibrated.

I didn't trim the brass. Book length is 2.590". My brass is avg 2.573". I neck size only. I clean gun around 25 to 30 rnds. Second to last patch has small amount of oil, then followed by dry patch. My chrono is out of service. Sent from my SM-G900V using Tapatalk

New Case: Head dia = .549", Primer Pocket dia = .209", Extractor groove = .473" Fired Case: Head dia = .552", Primer Pocket dia = .212", Extractor groove = .477" This one also had a blown primer.

Hello, I'm new to this forum and the 26 Nosler. I purchased a Browning X-Bolt Western Hunter and am reloading for it. I am using the Nosler Reloading Guide #8 for reference. Am using the 140 Gr Accubond bullets, Nosler Brass, Winchester LRM Primers, COAL is 3.30" (which is .060" jump for my...