Powerstroke
Handloader
- Feb 24, 2006
- 1,799
- 58
Ok.....This is the 5th time on reloading some of my .300RUM Brass....Remington brass. At the range last weekend I had one round that would not chamber.....couldn't get the bolt " in far enough " Aprox still an 1/8" out. I had already shot aprox 15 rounds. Once home, I noted on the body....just short of the neck a very slight buldge...about like the resize procedure went too far, but it's a sharp buldge. I just now ran a few more through the press and have the same issue on a couple of them, not all........ideas??? RCBS Full Length Dies
Thanks in advance!!
Thanks in advance!!
