Forster Co-Ax Press

[dezmick]

I am wanting to get one of these since it gets such great reviews, but i am also wanting to know if you have to use Forster dies with it or will Redding dies that i already have for both my 7mm WSM and 7mm 08 work with this press?

 

[DrMike]

You can use your Redding dies, but you'll want to get Forster dies when you see how great they are.

 

[dezmick]

I was looking on there web site and saw the mounting diagram, it has four holes just like my T-7, the only problem is the way i built my bench(used 2x4 basics kit) there is a 2x4 that runs right along the outer edge of the table top all the way around it, so on my T-7 it is only mounted with the two front bolts, i am wanting to know if that same setup would work for the Co-Ax, or if i should come up with some sort of different way to mount the press.

 

[rick smith]

You can use lag bolts in the front two holes which would allow the primer catcher plenty of space. Then use bolts/washers and nuts for the rear two holes.Rick.