Cleveland48
Handloader
- Jul 28, 2015
- 1,971
- 155
After a long wait I finally got the nerve to swap one of my howa rifles over to DBM for AICS magazines. I had to inlet the front of the trigger guard out a little. Also had to remove the metal magazine tab from the rear of the action to use the magazines. after all that I realized after I torqued everything down I had the front action screw hole to deep. it caused the front of the new floor plate to bend some. so I mixed up some epoxy and bedded the front of the bottm metal to build it back up. here is a pic of the tab I had to cut back to get magazines to seat.
Sent from my SM-N960U using Tapatalk
Sent from my SM-N960U using Tapatalk