I had a barrel made in a 264 Pac-Nor, just a tight chambered 264 win. Now I thought I may just have to use small base dies if the cases wouldn't chamber after firing once, but the neck is around .001 or.0015 too tight to allow a loaded round to chamber. It will chamber a new brass, but not with a bullet seated.
I have looked at neck turning equipment and think the Sinclair NT-3000 kit looks pretty good. Problem is, I haven't used any neck turning equipment before and could use any tips or advise you have got. Is this kit a good one, or shoud I look at the forester stuff???
CC.
I have looked at neck turning equipment and think the Sinclair NT-3000 kit looks pretty good. Problem is, I haven't used any neck turning equipment before and could use any tips or advise you have got. Is this kit a good one, or shoud I look at the forester stuff???
CC.