QL Request

tddeangelo

Handloader
May 18, 2011
2,023
20
My father is working up loads for a new-to-him 6.5x55 M70 Fwt (yes, he got real lucky).

He's looking at a few different bullets.....notably the 125gr BT, 130gr AB, and 140gr PT.

If someone could run QL on those three, I'd really appreciate it!

Thanks!
 
Cartridge : 6.5 x 55 Swedish
Bullet : .264, 120, Nosler BalTip 26120
Useable Case Capaci: 53.905 grain H2O = 3.500 cm³
Cartridge O.A.L. L6: 3.150 inch = 80.01 mm
Barrel Length : 22.0 inch = 558.8 mm
Powder : Alliant Reloder-22

Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !

Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms

-20.0 83 41.60 2315 1428 27571 9889 83.4 1.502
-18.0 85 42.64 2378 1506 29452 10272 85.0 1.464
-16.0 87 43.68 2441 1588 31469 10650 86.6 1.427
-14.0 89 44.72 2505 1672 33633 11019 88.1 1.390
-12.0 91 45.76 2569 1759 35954 11380 89.5 1.355
-10.0 93 46.80 2634 1848 38446 11730 90.9 1.314
-08.0 95 47.84 2699 1941 41129 12067 92.2 1.272
-06.0 97 48.88 2764 2036 44012 12390 93.4 1.232
-04.0 99 49.92 2830 2134 47117 12697 94.5 1.193 ! Near Maximum !
-02.0 101 50.96 2896 2235 50461 12987 95.5 1.155 ! Near Maximum !
+00.0 104 52.00 2962 2338 54077 13257 96.4 1.118 ! Near Maximum !
+02.0 106 53.04 3028 2444 57979 13506 97.3 1.083 !DANGEROUS LOAD-DO NOT USE!
+04.0 108 54.08 3095 2552 62204 13732 98.0 1.049 !DANGEROUS LOAD-DO NOT USE!
+06.0 110 55.12 3161 2662 66780 13934 98.6 1.016 !DANGEROUS LOAD-DO NOT USE!
+08.0 112 56.16 3227 2775 71711 14111 99.1 0.984 !DANGEROUS LOAD-DO NOT USE!
+10.0 114 57.20 3294 2891 77041 14259 99.5 0.953 !DANGEROUS LOAD-DO NOT USE!

Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba 104 52.00 3133 2616 66314 13257 99.8 1.026 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba 104 52.00 2740 2000 43309 12476 88.3 1.237

Cartridge : 6.5 x 55 Swedish
Bullet : .264, 130, Nosler AccuBond 56902
Useable Case Capaci: 52.511 grain H2O = 3.409 cm³
Cartridge O.A.L. L6: 3.150 inch = 80.01 mm
Barrel Length : 22.0 inch = 558.8 mm
Powder : Alliant Reloder-22

Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !

Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms

-20.0 82 40.00 2237 1444 27658 9780 85.0 1.554
-18.0 84 41.00 2296 1522 29526 10148 86.6 1.515
-16.0 86 42.00 2356 1603 31524 10508 88.1 1.477
-14.0 88 43.00 2417 1686 33665 10861 89.5 1.440
-12.0 90 44.00 2478 1772 35957 11204 90.8 1.403
-10.0 92 45.00 2539 1861 38420 11536 92.1 1.361
-08.0 94 46.00 2601 1952 41059 11855 93.3 1.318
-06.0 96 47.00 2663 2046 43897 12159 94.4 1.277
-04.0 98 48.00 2724 2143 46946 12448 95.4 1.237 ! Near Maximum !
-02.0 100 49.00 2787 2241 50228 12720 96.3 1.198 ! Near Maximum !
+00.0 102 50.00 2849 2343 53763 12972 97.1 1.161 ! Near Maximum !
+02.0 104 51.00 2911 2446 57575 13204 97.9 1.126 !DANGEROUS LOAD-DO NOT USE!
+04.0 106 52.00 2973 2552 61692 13414 98.5 1.091 !DANGEROUS LOAD-DO NOT USE!
+06.0 108 53.00 3035 2660 66111 13601 99.0 1.057 !DANGEROUS LOAD-DO NOT USE!
+08.0 110 54.00 3097 2770 70864 13762 99.4 1.025 !DANGEROUS LOAD-DO NOT USE!
+10.0 112 55.00 3159 2881 75996 13898 99.7 0.993 !DANGEROUS LOAD-DO NOT USE!

Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba 102 50.00 3007 2610 65799 12874 100.0 1.066 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba 102 50.00 2641 2013 43024 12301 89.5 1.283

Cartridge : 6.5 x 55 Swedish
Bullet : .264, 140, Nosler PART SP 16321
Useable Case Capaci: 52.746 grain H2O = 3.425 cm³
Cartridge O.A.L. L6: 3.150 inch = 80.01 mm
Barrel Length : 22.0 inch = 558.8 mm
Powder : Alliant Reloder-22

Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !

Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms

-20.0 80 39.44 2184 1482 28189 9978 87.2 1.596
-18.0 82 40.43 2241 1561 30077 10337 88.6 1.556
-16.0 84 41.41 2298 1642 32094 10689 90.0 1.516
-14.0 86 42.40 2356 1726 34253 11031 91.3 1.478
-12.0 88 43.38 2414 1812 36563 11363 92.5 1.441
-10.0 90 44.37 2473 1901 39037 11682 93.7 1.397
-08.0 92 45.36 2531 1992 41687 11988 94.7 1.353
-06.0 94 46.34 2590 2085 44529 12278 95.7 1.311
-04.0 96 47.33 2648 2180 47579 12552 96.6 1.271 ! Near Maximum !
-02.0 98 48.31 2707 2278 50855 12807 97.4 1.232 ! Near Maximum !
+00.0 100 49.30 2766 2378 54372 13044 98.1 1.195 ! Near Maximum !
+02.0 102 50.29 2824 2480 58122 13259 98.6 1.159 !DANGEROUS LOAD-DO NOT USE!
+04.0 104 51.27 2883 2584 62134 13452 99.1 1.124 !DANGEROUS LOAD-DO NOT USE!
+06.0 106 52.26 2941 2689 66440 13622 99.5 1.090 !DANGEROUS LOAD-DO NOT USE!
+08.0 108 53.24 2999 2797 71068 13767 99.8 1.057 !DANGEROUS LOAD-DO NOT USE!
+10.0 110 54.23 3057 2906 76047 13886 99.9 1.026 !DANGEROUS LOAD-DO NOT USE!

Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba 100 49.30 2910 2633 66208 12807 100.0 1.099 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba 100 49.30 2572 2056 43423 12505 91.2 1.319
 
Those look pretty danged good for that little Swede Tom! I imagine your Dad is going to fall in love with it once he gets it sorted out from the horrible trigger it must have! :lol:
 
lol, yeah, it's a real heavy trigger. I think it weighed at 3lbs 14oz. with about nill for over travel or creep. He's suffering badly with that trigger.
 
Tom,

I've played a little with mine 7828 and 4350 with the 125's haven't done a lot but I think you will be better off with the 130's and 140's. In mine I can only load the 125's out to 3.100" because those are so short. At 3.150" they are barely in the neck. If you want some 125's I can send you some just PM me.
 
Back
Top