Rem 700 trigger disassembly

[CAhunter]

Hey guys! Just looking for some info on disassembling a factory 700 trigger. I have adjusted them before but was thinkning of trying to polish the sear and honing some spots. Just wondering if you thought it might help a factory trigger at all? Just looking for some insight. Figured if i messed it up it would give me an excuse to get a timney or jewell.
THANKS!!

 

[Powerstroke]

Never taken one down all the way myself. Just had my Smith adjust / polish and respring one of the new X-marks. It turned out phenominal. I believe it was a Holland Spring Kit.

 

[FOTIS]

A can of worms buddy. I can adjust a 700 trigger in 5 minutes without taking it down. Careful

 

[CAhunter]

thanks guys. I think im gonna just get the holland spring kit. It looks like it should work for what I need and they said install is pretty easy. Thanks powerstroke

 

[Powerstroke]

As POP mentioned.... Caution....
I've ajusted one or two in my day, again like POP stated without taking them down....... but opted for a professional smith to do this one.

 

[Desert Fox]

Don't know about the X-Mark but I've done a few of the older model. Polishing or honing of the sear and lever bearing surface will reduce creep and the trigger will have a much smoother release. You can used Dremmel or a fine sharpening stone. Carefull not to round the edge of the bearing surfaces.

Here's a good instruction for adjusting the trigger after you're done with the above.

http://www.theoutdoorwriter.com/shootin ... rigger.htm