QL question 338 federal 210 partition IMR 8208

338federal

Beginner
Sep 17, 2016
3
0
Anyone able to run quick load for 338 federal using 210 partitions and IMR 8208 powder.

Thanks Chuck
 
Welcome aboard, Chuck.

Code:
Cartridge          : .338 Federal
Bullet             : .338, 210, Nosler PART SP 16337
Useable Case Capaci: 48.541 grain H2O = 3.152 cm³
Cartridge O.A.L. L6: 2.820 inch = 71.63 mm
Barrel Length      : 22.0 inch = 558.8 mm
Powder             : IMR 8208 XBR

Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !

Step    Fill. Charge   Vel.  Energy   Pmax   Pmuz  Prop.Burnt B_Time
 %       %    Grains   fps   ft.lbs    psi    psi      %        ms

-20.0   81    36.24   2047    1954   31574   5634     92.0    1.472
-18.0   83    37.15   2095    2046   33606   5796     93.0    1.432
-16.0   85    38.05   2142    2139   35752   5953     93.9    1.394
-14.0   87    38.96   2189    2235   38035   6104     94.8    1.356
-12.0   89    39.86   2236    2332   40462   6249     95.6    1.318
-10.0   91    40.77   2283    2431   43043   6387     96.3    1.281
-08.0   93    41.68   2330    2532   45789   6519     97.0    1.246
-06.0   95    42.58   2377    2634   48712   6643     97.6    1.212
-04.0   97    43.49   2423    2738   51825   6759     98.1    1.180  ! Near Maximum !
-02.0   99    44.39   2469    2844   55143   6866     98.6    1.148  ! Near Maximum !
+00.0  101    45.30   2516    2951   58682   6965     99.0    1.118  ! Near Maximum !
+02.0  103    46.21   2561    3059   62459   7055     99.4    1.089  !DANGEROUS LOAD-DO NOT USE!
+04.0  105    47.11   2607    3169   66495   7135     99.6    1.061  !DANGEROUS LOAD-DO NOT USE!
+06.0  107    48.02   2652    3281   70812   7205     99.8    1.033  !DANGEROUS LOAD-DO NOT USE!
+08.0  109    48.92   2698    3393   75435   7264     99.9    1.007  !DANGEROUS LOAD-DO NOT USE!
+10.0  111    49.83   2743    3507   80392   7313    100.0    0.981  !DANGEROUS LOAD-DO NOT USE!

Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba    101    45.30   2612    3181   69288   6732    100.0    1.047  !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba    101    45.30   2381    2643   48401   6886     94.3    1.212
 
Thanks to you both for the info. This is the last on my initial load development, but just couldn't find data on it. I'm only going to run speed tests to start. I see no sense anymore in wasting time & $$ on accuracy tests, only to find that it's a moped later. 8208 and RL-15 are on the 'have-on-hand list, if not up to snuff ...LVR next, at least for the 210 PT.

Please keep us up to date on how it works, I will as soon as I can.
 
What would be the best powder in the 338 federal and the 200gr Speer; my Ruger 77 Hawkeye doesn't shoot it and MR2000 very well. Any QL help out there? :)
 
Best? The 338 Federal doesn't appear to be particularly fussy. Any of a number of powders should give you good results. Some I would consider include TAC, RL15, IMR4198, BL(C)2 and A2230.
 
I'm using 8208,2230,LVL and TAC. IMR 8208 is my go to powder for 160-210 gr bullets, AA2230 gets better velocity in the 160-180 range and LVL is best velocity over 210gr. With the 210 Partition I can safely get 2575fps with 8208 and 2625fps with LVL and I don't think any animal is going to notice 75fps.

Shooting 8208 with the 180gn AB I'm getting just under 2800fps
Shooting AA2230 and 160gn TTSX I'm getting just over 3000fps

Now if I can just pick a bullet for whitetail I like them all.
 
I can tell you as fact, from personal experience, that a 200gr .338 @ 2550fps will spin a 7'3" black bear 270 degrees sideways, in mid air, at 30 yds.

I've got 210's loaded and boxed.....now can some help me find a range that's not 2hrs from the house ?
 
Back
Top