Latest activity

What's new New posts New media New media comments New profile posts Latest activity
  • C
    Charlie-NY replied to the thread Hearing Loss.
    Fortunately, my health insurance covers hearing aids, including some rather expensive models. However, I have noticed that hearing aids...
  • truck driver
    truck driver posted the thread Hearing Loss in Off Topic.
    I've worn hearing aids for quite a while and one of them died on me so I've been looking around for replacements since I can't afford to...
  • DrMike
    DrMike replied to the thread 26 nosler loading question.
    Perhaps this additional data could be suggestive for you. Cartridge : .26 Nosler Bullet : .264, 120, Nosler E-TIP...
  • DrMike
    DrMike replied to the thread 26 nosler loading question.
    Would this help? Cartridge : .26 Nosler Bullet : .264, 130, Hornady CX 26178 Useable Case Capaci: 89.200 grain H2O...
  • Ralt71
    Ralt71 reacted to Hunter26's post in the thread 142gr ABLR vs buck with Like Like.
    Finally got some measurements on them. One on the left is 72 grains (1st shot) & the other one is 70 grains, so approximately 50% weight...
  • Ralt71
    Ralt71 reacted to Hunter26's post in the thread 142gr ABLR vs buck with Like Like.
    I got the bullets cleaned up and took some more pics. The one with more shank and no fragments was shot one. I'll get some weights and...
  • A
    Arrowman posted the thread 26 nosler loading question in Reloading.
    I shoot alot of nosler etip bullets, but I have ran into a couple issues. 1st issue i dont see 130 grain et bullet for the 26 nosler so...
  • filmjunkie4ever
    filmjunkie4ever replied to the thread Browning BAR 25-06.
    I never knew Browning made the BAR in the .25 Niedner!! My B-I-L is absolutely nuts for anything Browning, but especially the BAR. I...
  • longrangehunter
    longrangehunter reacted to salmonchaser's post in the thread Wrong side of the track with Wow Wow.
    Found this guy during deer season, wrong side of the fence.
  • Yoteklr
    Yoteklr reacted to jimbires's post in the thread Primer Question with Like Like.
    ** always remove live primers before annealing ** I remove the decapping pin in instances that I forgot to resize the brass . if...
  • longrangehunter
    longrangehunter replied to the thread Browning BAR 25-06.
    I’m of the opinion that was typical for a Browning BAR, maybe a little better? I’ve never seen one shoot much less than an inch...
  • T
    TackDriver284 replied to the thread Browning BAR 25-06.
    I remember I struggled with trying to get my Gramp's .243 BAR to shoot accurately, wasn't my loads either. It's probably due to the...
  • filmjunkie4ever
    filmjunkie4ever reacted to truck driver's post in the thread Primer Question with Like Like.
    I've done numerous times with no ill side effects. Just make sure your hands are dry and clean when handling the primers and take it...
  • filmjunkie4ever
    filmjunkie4ever replied to the thread 2025 Hunting Season.
    Wow! Great bucks by both of those ladies! I wish Oregon would allow us to use crossbows for archery season!!
  • wvbuckbuster
    wvbuckbuster reacted to SJB358's post in the thread Browning BAR 25-06 with Like Like.
    Check the forearm screw tension. Might not be your loads, might just be the gun is wanting something different done.
Show older items
AMMUNITIONAmmunition BULLETSBullets BRASSBrass FirearmsFirearms GearGear
Back
Top