Recent content by archeratlrg

I have both and love them both.

I've taken over 25 Rosie bulls and a few Rocky mtn. With the 160's either accubond or partitions with a few 175 gr partitions thrown in. You won't have any issues. Federal 160gr Trophy bonded, either components for reloading or loaded ammo you will be golden!

Looking for some quuck load info to give me an idea of my pressures. Im shooting an old Rem 700 with the original stainless barrel from 1962. The following loads were worked up in the 60's and I still use them. I'm shooting 175gr Partitions in front of 67gr of H4831sc this load shoots 1...

Im going to try that in my Mashburn.

Ive been getting 3435fps with my 7mm Rem mag and 140 gr partitions for 50 years, Ballistic tops since they came out with the. Im over 3300 with 150's out of a 1962 Original stainless barrel, 700 Remington and a real stiff load of H4831sc.

I know this is an older post, but im using 68.5-69gr of H4831sc behind the 160gr partitions/accubonds for 3100 out of my old stainless barreled 700 Remington. Faint electoral marks, but not enough to worry about. 6-8 loading on my brass so thats good too. 70.5-71 grains of H4831sc will get me...

Hey Preacher, I haven't seen much data for the Re33 in the 7mm Rem mag. What were your start loads? Mine is throated for the 175 part seated to base of neck and .010 off lands. Haven't tried it in my Mashburn yet either. 5 shoulder surgeries in 2 1/2 years with a replacement of a...

160 gr accubond or partition or 175gr partition although I have a lot of 150 ABLR's and 175gr ABLR's.

What start load do you recommend?

Have or anyone else you tried the Mashburn with Re 26?

I know this is an older thread but is anyone using Re26 for their 7mm Mashburn Super? Would love to hear some feeeback.