Search results

Fotis, I am shooting a Mark V Accumark. Not sure what the twist is. Jimbeaux

as always Dr. Mike, thanks for your quick reply. Jimbeaux

Could one of our esteemed members please run a composite QL for 7mm Weatherby mag, 168 gr Nosler ABLR, Weatherby cases, 26" barrel. Thanks Jimbeaux

Cleveland, any velocity info with your loads? Jimbeaux

As usual Dr Mike, Thanks for your quick response. Jimbeaux

Would someone run a 6.5 Creedmoor, 140 gr Nosler CC, RL 16, Hornady brass, 24" barrel QL? Thanks Jimbeaux

ill have to give this a try. thanks

Dwh, I tried at .020" off lands and it was not good. That was the 2.856" load referenced. You think I should try one at .010" off the lands? Jimbeaux

Thanks. In Louisiana I am not at all worried about cold weather changes and try to work up my loads in the summer heat of 80-100 deg. Right now it is 80-90 deg each day. Today I reshot my 45.0 gr load at 2.826" and got .860" group, basically the same as the .740" group I got earlier. However...

Nimrod ans Scotty, Thanks for the input. I am at 190 ft elevation. Jimbeaux

Come on guys, 29 views and no comments? Dr Mike, Fotis, Scotty, Guy, Dr Vette, surely one of you have some comments or suggestions Jimbeaux

Guys, I recently bought a Savage BA 10 Stealth in 6.5 Creedmoor and have started my load development. I know that H4350 is "THE" powder for 6.5 CM but finding it is another problem. I happen to have a very good supply of VV N160 so decided to try and work up a good load using it and see what...

Perfect - Thanks Jimbeaux

I would appreciate if someone could run a QL on 6.5 Creedmoor, VVN 160 powder, 24" barrel, Hornady brass and 140 gr Nosler RDF bullets. Thanks Jimbeaux

I recently purchased a used Rem 700 min 7mm Rem Mag. Someone had gone to great pains and done some excellent work customizing this rifle to be a very light weight "Mountain Rifle" type, I surmise. It has a pencil thin, 22 in barrel, very lightweight synthetic stock, Control mounts and excellent...

I have a Lyman machine. It does a great job on primer pockets, both trueing and cleaning, reaming out crimped primer pockets and inside chamfering. I am not quite as happy with the outside neck deburring after trimming, but I have found one technique to make it work acceptably. I would not be...

In the past , I had read several posts here regarding failure with Winchester primers; ie leaking gas past the primer with a pin hole near the primer wall. I found information on several lots that had failures and compared the lots I had and none were the same but one was close. I e-mailed...

I much prefer to neck up 243 brass to 260. Have done this many times without problem.

Here is some data that I have, but not exactly what you are looking for. I have a CZ 550 FS with 20" barrel. 120 gr NBT, 47.0 gr IMR 4350, 2760 FPS, 1" (3 shots) 140 gr NBT, 51.0 gr H4831, 2760 fps, 1.25" (may be a tad hot) 140 gr NBT, 47.5 gr VVN160, 2745 fps, 1"

I neck up 243 brass all the time to 260 without issue. However, I keep my chrome plated 243 brass for this purpose so that it is a visual flag.