Search results

any holes patched in it?

In an AR10, would a 6mm creed be a better choice? Use up less powder room for bullet storage shooting heavies?

Anyone looked through one? Put one on a rifle, quality is way above the 300 dollar price tag

whats the formula to figure rpm's? edit: looked it up , have ran 160 accubonds to 289k rpms

awesome little round for deer hunting!

caldwell

Been looking for some RE33, have read good things about it in the edge

Did get around to measuring the test group from yesterday, 3 shots at 225 yards went . 162"

As I said, no pressure signs, none, primers are still round on the edges. A tech at sierra once told me that when using fed215 primers, due to the soft cups of them, do not assume its high pressure if a flat fed. 215 is all you see. wait till you see one more sign such as ejector marks, heavy...

new ADG brass, have less than 20 rounds through it

have all but given up looking for nosler bullets, along with berger. am shooting the 300 a-tip bc is .836

the purpose of this rifle is to take a whitetail at 1 mile (1760 yards) so I want all I can get out of it.

its that yeller tungsten that some companys use for casings is what causes it.

prrobably the expander ball causing it, run a case into the sizer, loosen the lock nuts to the decapping rod, back the ram off till the expander ball makes contact, pull down on the ram till it makes firm contact, then tighten the lock nut. see if that helps.

working with a 338 Edge, the data I have found is a max load for a 300 hornady A-tip is 90 gr. of H1000 for 2846 fps. am now at 2823 with 92 gr. H1000. running fed. 215's and they are not starting to flatten, no casehead expansion. do I go up a grain? going to anyways probably but want your...

Almost close enough for me to shoot🤣

Could be they were loaded with powder on the fast burning side causing pressure to peak early. Or bullet in the lands creating high pressure

Loose pockets are caused by casehead expansion, which is caused by pressure. How many times have they been loaded after firing the factory ammo?

if you have runout problems, try seating the bullet in steps, start the bullet, back the ram off spin the case 60 degrees, seat it a bit more spin the case, then finish seating.

Saw that coming !