25/06 Accubond

[Guest]

I need some good loads to try for the AccuBond in my 25/06. Any suggestions?

 

[jjmp]

bkarl, yes i asked the same question my self, nosler told me use the 115 grain data, with imr 4350...... i did rite from nosler reload guide number 4... worked great shot super from my 26 inch shilen barrel. enjoy jjmp

 

[Guest]

Thanks jjmp, I will give it a shot or three!

 

[Guybo]

The best powder i found for the 25.06 and the 110gr AccuBond is RE22. My best group with this powder measured .325 and that was with 53.5 grains. This isn't a max load in my rifle but it could be in yours so if you try it start low and work up to it. Good Luck. Mike

 

[warden]

54.0gr. of imr4831 is giving me 3200fps w/ consistant .75" or less groups out of my ruger (tang safety) .25/06. last week, while on a mule deer hunt in montana i got the opportunity to use my antelope doe tag. it was only 200 yards, but the 110ab did number on the doe. the bullet entered behind the left shoulder and blew out the left shoulder with about a 1" exit hole. on a side note, the 140gr. AB out of my .270 did the job on a 4x5 muley buck at 343yards as well.

 

[remingtonman_25_06]

My Winchester model 70 25-06 loves H-4831 powder. I have never had a rifle so fond of a particular powder. Anyways, 51g H-4831, CCI BR2, W-W case, 3.250" Shoots .4 at 100 yards. Tested at 525 yards and shot a 3.5 inch group. Will be a nice 600 yard coyote/antelope/deer combination.