7mm mag

sask boy · May 16, 2016

Good morning, some people would say I am being lazy :wink: but I was wondering if anyone has been playing with the 7mm mag and H1000 with 168gr ABLRs on top. Was told that around 69grs. should get the job done but was wondering on AOL.
This load is going to be tried out of a Browning X-bolt.
Thanking everyone in advance for the information.

Blessings,
Dan

Elkman · May 16, 2016

Dan I tried the ABLR's but did not have any luck. Start at magazine length then work back towards the factory AOL, .01 at a time and see if that works. I also tried H-1000 and had good success but went to H-4350 for my most historic accurate load. I am currently working on a 300 B and as soon as I finish that I will get back to the 7mm. I believe that 66 grains was my most accurate load but I could be wrong, I am once again in a different area than my data.