TackDriver284
Handloader
- Feb 13, 2016
- 2,735
- 2,724
Been so long since I annealed any of my brass since last year, uncovered the BenchSource and ran 50 pieces of 6.5 Creedmoor Nosler brass through a decapper die first, cleaned up the carbon on necks and body. Used 3 pieces of brass, brushed 650 degree Temilaq on inside of the necks and 450 degree on the body from the shoulder to the base, ran it through the flame and once timer is set correctly, put in the 47 remaining pieces. I love the way the two flames hits together and centered. Prepping them soon with Nosler Ballistic Tips and H4350 for this deer season. 3 months to go for rifle and 2 for bow. Good luck to everyone this season.
P.S. In the picture the brass isn't in the final position to spin in the flame yet, since it was moving on the wheel towards it, see the case being dropped into the pan. :wink:
P.S. In the picture the brass isn't in the final position to spin in the flame yet, since it was moving on the wheel towards it, see the case being dropped into the pan. :wink:
