Full length sizing

[spires5d]

I have been full length resizing some of my 7mm mag cases and I have noticed that where the taper goes to the neck in one or two spots,the case is denting in. Am I going up into the die too far,or do I need to back off a little?
Or what causes this? These are new RCBS dies. Need some help.



Noslers Rock

 

[DevilDawg]

You have too much lube on the case!!!

 

[rick smith]

Clean all the lube out of the die, only lube the bottom half of the case.Rick.

 

[C.Smith]

Somthing that I do is when I first put lube on my pad it usually puts too much the case and causes the hydrolic dents you are describing. I put one lubed case through and then one non lubed one right after. I keep alternating this way for a while and it seems to work great.

I just did it last night working on a .270 load for my nephew.

Corey