NOSLER 270 (.277) 165gr SP AccuBond-LR

mike06

Beginner
Oct 22, 2015
62
47
Anyone here that has tried this bullet yet? Interested in some load data if anyone has any suggestions? Thanks Mike
NOSLER 270 (.277) 165gr SP AccuBond-LR
 
What cartridge? You have the requisite 1:8.5 twist or faster barrel?

Sent from my SM-G892A using Tapatalk
 
amassi":cdkxy6zx said:
What cartridge? You have the requisite 1:8.5 twist or faster barrel?

Sent from my SM-G892A using Tapatalk
I have a 270 Win. 1 in 10 twist 24 inch barrel.
 
mike06":2sr41vb1 said:
amassi":2sr41vb1 said:
What cartridge? You have the requisite 1:8.5 twist or faster barrel?

Sent from my SM-G892A using Tapatalk
I have a 270 Win. 1 in 10 twist 24 inch barrel.
They wont stabilize out of a 10 twist

Sent from my SM-G892A using Tapatalk
 
amassi":3anqo3sj said:
mike06":3anqo3sj said:
amassi":3anqo3sj said:
What cartridge? You have the requisite 1:8.5 twist or faster barrel?

Sent from my SM-G892A using Tapatalk
I have a 270 Win. 1 in 10 twist 24 inch barrel.
They wont stabilize out of a 10 twist

Sent from my SM-G892A using Tapatalk
OK thanks I have shot the 150 AccuBond LR very little but manage to shoot a .865 group at 100 yards 2777 fps. Guess I will stay with them. Thank you for the quick response.
 
i have HUNDREDS of 165 ABLR for my 7 twist 270Bee. using n570 its a BAD 3200FPS with a 27" barrel. 3.45" COAL, but i have many different COAL i use. my chamber is cut .600" long.


Cartridge : .270 Weath. Mag.
Bullet : .277, 165, Nosler AccuBond LR
Useable Case Capaci: 73.160 grain H2O = 4.750 cm³
Cartridge O.A.L. L6: 3.450 inch = 87.63 mm
Barrel Length : 27.0 inch = 685.8 mm
Powder : Vihtavuori N570 *C

Predicted data by increasing and decreasing the given charge,
incremented in steps of 3.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !

Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms

-30.0 75 53.20 2025 1503 18045 8669 73.4 2.311
-27.0 78 55.48 2139 1676 20456 9422 77.2 2.173
-24.0 81 57.76 2254 1862 23174 10161 80.8 2.045
-21.0 84 60.04 2371 2060 26241 10877 84.2 1.926
-18.0 88 62.32 2489 2270 29705 11560 87.3 1.815
-15.0 91 64.60 2607 2491 33627 12199 90.1 1.711
-12.0 94 66.88 2726 2723 38073 12787 92.6 1.614
-09.0 97 69.16 2845 2966 43126 13314 94.8 1.523
-06.0 100 71.44 2963 3218 48888 13771 96.6 1.438
-03.0 104 73.72 3081 3478 55476 14152 98.0 1.358 ! Near Maximum !
+00.0 107 76.00 3198 3747 62998 14449 99.0 1.283 ! Near Maximum !
+03.0 110 78.28 3314 4023 71556 14655 99.7 1.214 !DANGEROUS LOAD-DO NOT USE!
+06.0 113 80.56 3428 4306 81332 14765 100.0 1.148 !DANGEROUS LOAD-DO NOT USE!
+09.0 117 82.84 3541 4594 92557 14799 100.0 1.086 !DANGEROUS LOAD-DO NOT USE!
+12.0 120 85.12 3652 4888 105521 14813 100.0 1.028 !DANGEROUS LOAD-DO NOT USE!
+15.0 123 87.40 3763 5188 120600 14808 100.0 0.973 !DANGEROUS LOAD-DO NOT USE!

Results caused by ± 15% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 15% relative to nominal value:
+Ba 107 76.00 3441 4338 88712 13564 100.0 1.118 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 15% relative to nominal value:
-Ba 107 76.00 2785 2841 41565 13379 86.3 1.540


LETS BE CLEAR, THIS CANNOT BE USED WITH A STOCK CHAMBER!!!!!!!!!!!!!!! even weatherby freebore is not enough.

MY CHAMBER IS A NATIONAL MATCH CHAMBER WITH A .600" THROAT. my bullets touch up a 3.82" COAL.

HOWEVER, it illustrates what can be achieved with a long barrel, a match chamber, and a long throat that matches the intended bullets.

its really not suitable for a 140 GR SST. i had to crimp 140 SST HARD to get the retumbo i used for that bullet. i only achieved 2800 fps with a 140SST with unburned powder and the case didnt expand.

its a trade off to get the 270 Bee to really perform with 150 to 175gr.

so you know.
 
Last edited by a moderator:
Back
Top