Why does Nosler not list the "Trim to Length" in any of it's manuals? My other manuals and most data from powder manufactures lists both "Case Length" and "Trim to Length". Nosler has left this info out, Why?
Also if the "Trim to Length" is as simple as .020 less than max, Why is that little bit of info not mentioned in Noslers Manual. If it is mentioned, I can't find it.
Steve, Where do you find -.020" as trim to figure? I`ve always seen, as Tailgunner posted, the standard trim to lenght reduction as being 0.010" under max. The shorter lgt likely won`t hurt but if used enough the possiblity of carbon build up in the chamber in front of the neck could cause some tight neck problems later if longer cases are used.
