QL request

[OU812]

If this has been done already please forgive me but I can't seem to locate it here. If it's not to much trouble could someone QL a 264 win mag, 26 inch barrel, 140 AccuBond?

Would Nosler allow QL requests to be put in the bullet test section under the given caliber? Lots of people would benefit from the info and it would be easy to find. just a thought.

 

[DrMike]

Cartridge          : .264 Win. Mag.
Bullet             : .264, 140, Nosler AccuBond 39457
Useable Case Capaci: 74.854 grain H2O = 4.860 cm³
Cartridge O.A.L. L6: 3.340 inch = 84.84 mm
Barrel Length      : 26.0 inch = 660.4 mm

Predicted Data for Indicated Charges of the Following Powders.
Matching Maximum Pressure: 61500 psi, or 424 MPa
or a maximum loading ratio or filling of 110 %
These calculations refer to your specified settings in QuickLOAD 'Cartridge Dimensions' window.
C A U T I O N : any load listed can result in a powder charge that falls below minimum suggested
loads or exceeds maximum suggested loads as presented in current handloading manuals. Understand
that all of the listed powders can be unsuitable for the given combination of cartridge, bullet
and gun. Actual load order can vary, depending upon lot-to-lot powder and component variations.
USE ONLY FOR COMPARISON !

46 loads produced a Loading Ratio below user-defined minimum of 90%. These powders have been skipped.
Powder type          Filling/Loading Ratio  Charge    Charge   Vel. Prop.Burnt P max  P muzz  B_Time
                                      %     Grains    Gramm   fps     %       psi     psi    ms
---------------------------------  -----------------------------------------------------------------
Vihtavuori N570                    100.1     72.8     4.72    3238    98.7    61500   15797   1.275  ! Near Maximum !
Alliant Reloder-33                 100.6     76.2     4.94    3223    99.0    61500   15593   1.278  ! Near Maximum !
Alliant Reloder-50                 106.3     79.4     5.14    3217    98.6    61500   15923   1.305  ! Near Maximum !
Hodgdon H870                       106.2     75.7     4.90    3212    99.6    61500   15177   1.281  ! Near Maximum !
Hodgdon Retumbo                    103.7     72.0     4.66    3194   100.0    61500   13708   1.267  ! Near Maximum !
Norma 217                          105.9     72.0     4.66    3192   100.0    61500   14094   1.292  ! Near Maximum !
Vihtavuori N560                     91.8     64.8     4.20    3169    99.9    61500   14115   1.271  ! Near Maximum !
Norma MRP 2                         99.3     68.5     4.44    3165   100.0    61500   14004   1.286  ! Near Maximum !
Accurate MAGPRO                     92.1     67.6     4.38    3164    99.5    61500   14337   1.280  ! Near Maximum !
IMR 7828 SSC                        90.9     64.4     4.17    3159   100.0    61500   13653   1.261  ! Near Maximum !
IMR 7828                            96.1     64.4     4.17    3159   100.0    61500   13653   1.261  ! Near Maximum !
Hodgdon H1000                      100.8     68.8     4.46    3150   100.0    61500   13337   1.256  ! Near Maximum !
Vihtavuori 24N41                   103.2     75.9     4.92    3146    94.5    61500   14627   1.261  ! Near Maximum !
Hodgdon 50BMG                      108.6     76.1     4.93    3143    90.9    61500   14962   1.269  ! Near Maximum !
Alliant Reloder-25                  97.0     66.6     4.32    3142   100.0    61500   12978   1.276  ! Near Maximum !
Alliant Reloder-22                  92.2     64.3     4.17    3137   100.0    61500   13403   1.277  ! Near Maximum !
Winchester WXR                      94.6     64.6     4.19    3136   100.0    61500   13431   1.277  ! Near Maximum !
Hodgdon US 869                     108.3     79.6     5.16    3134    94.5    61500   14661   1.275  ! Near Maximum !
Accurate 8700                      110.0     79.2     5.13    3126    98.2    59315   14319   1.288  ! Near Maximum !
Vihtavuori 20N29                   110.0     81.7     5.29    3120    96.3    59412   14741   1.305  ! Near Maximum !
Ramshot Magnum                      92.1     69.2     4.48    3111   100.0    61500   12799   1.280  ! Near Maximum !
Hodgdon H4831                       94.9     63.6     4.12    3092    99.9    61500   12927   1.263  ! Near Maximum !
Hodgdon H4831 SC                    91.2     63.6     4.12    3092    99.9    61500   12927   1.263  ! Near Maximum !
Vihtavuori N170                    103.7     70.8     4.59    3089    97.7    61500   13632   1.286  ! Near Maximum !
Alliant Reloder-23                  94.0     63.5     4.11    3071   100.0    61500   12037   1.291  ! Near Maximum !
Vihtavuori N160                     95.3     63.0     4.08    3048   100.0    61500   12203   1.267  ! Near Maximum !
Vihtavuori N165                     94.8     64.7     4.19    3047   100.0    61500   11983   1.280  ! Near Maximum !
Accurate 3100                       92.5     63.8     4.13    3033   100.0    61500   11811   1.308  ! Near Maximum !

 

[OU812]

Thanks Mike.

 

[SJB358]

I'm sorry I didn't see this earlier. Don't be surprised if it takes a little more powder than what QL says to get those speeds Bill. WW and Nosler cases are very spacious so it took some work with Mike to get me where I am. If you find the accuracy your looking for, Retumbo should give you a solid 3200 without drama or killing primer pockets. That's a load that shoots scary flat. I use 25 but Retumbo should get there with a little less PSI. 25 was a touch more accurate for me too. Both should be easy to get to shoot if the barrel isn't bent! :lol:

 

[OU812]

I'm sorry I didn't see this earlier. Don't be surprised if it takes a little more powder than what QL says to get those speeds Bill. WW and Nosler cases are very spacious so it took some work with Mike to get me where I am. If you find the accuracy your looking for, Retumbo should give you a solid 3200 without drama or killing primer pockets. That's a load that shoots scary flat. I use 25 but Retumbo should get there with a little less PSI. 25 was a touch more accurate for me too. Both should be easy to get to shoot if the barrel isn't bent! :lol:

Thanks Scotty. I'm going to try Retumbo and RL33 to start and see what happens. Being a Winchester guy do you know off hand which way the barrels are usually bent? :mrgreen:

 

[DrMike]

Being a Winchester guy do you know off hand which way the barrels are usually bent? :mrgreen:

Depends on which tire was flat when you jacked up the car. Oops! That was Remingtons. :lol:

 

[OU812]

Being a Winchester guy do you know off hand which way the barrels are usually bent? :mrgreen:

Depends on which tire was flat when you jacked up the car. Oops! That was Remingtons. :lol:

That cuts deep Mike. :grin:

 

[SJB358]

I'm sorry I didn't see this earlier. Don't be surprised if it takes a little more powder than what QL says to get those speeds Bill. WW and Nosler cases are very spacious so it took some work with Mike to get me where I am. If you find the accuracy your looking for, Retumbo should give you a solid 3200 without drama or killing primer pockets. That's a load that shoots scary flat. I use 25 but Retumbo should get there with a little less PSI. 25 was a touch more accurate for me too. Both should be easy to get to shoot if the barrel isn't bent! :lol:

Thanks Scotty. I'm going to try Retumbo and RL33 to start and see what happens. Being a Winchester guy do you know off hand which way the barrels are usually bent? :mrgreen:

33 should be REALLY good. Always wanted to try it as it promised ALOT of speed with 140's.

 

[OU812]

I'm sorry I didn't see this earlier. Don't be surprised if it takes a little more powder than what QL says to get those speeds Bill. WW and Nosler cases are very spacious so it took some work with Mike to get me where I am. If you find the accuracy your looking for, Retumbo should give you a solid 3200 without drama or killing primer pockets. That's a load that shoots scary flat. I use 25 but Retumbo should get there with a little less PSI. 25 was a touch more accurate for me too. Both should be easy to get to shoot if the barrel isn't bent! :lol:

Thanks Scotty. I'm going to try Retumbo and RL33 to start and see what happens. Being a Winchester guy do you know off hand which way the barrels are usually bent? :mrgreen:

33 should be REALLY good. Always wanted to try it as it promised ALOT of speed with 140's.

So soon as I get everything here and mounted up I'll let you know how 33 does.