TackDriver284
Handloader
- Feb 13, 2016
- 2,505
- 1,970
I had this reloading table for a little over 20 years when I started off as a noobie reloader. lol It started to sag a little and bullets started rolling off so I decided to remove the table and refinish it and find out what was causing it to sag. After extensive sanding outside to remove tool marks / pits in the table and removed most of the old stain finish. Reassembled the table with new screws, minor adjustments and bolted to the wall with 4 inch screws. Now its perfectly even and ready for some sealer. New Redding press is on the floor awaiting its new permanent home.