you get what you pay for ?????????????

[okie2]

the 6.5 rem mag is from Savage called the tiger shark it was $200.00
The one on the 7 mag is from Boyds called the ross thumbhole this stock weighs 2 1/2 pounds
they are dropin fit I did nothing to it but bolt my rifle in it this one was $79.00
now they are $99.00.

http://www.boydsgunstocks.com/

 

[FOTIS]

Looks good.

BTW if one more grain blew the primer, you might want to go down a bit.

 

[okie2]

I did I backed it down to 47.0 grains it is still that accurate.

 

[FOTIS]

Good deal.

 

[SCRUBS]

Thanks for the info okie2, and nice shooting!

I have one of my 110`s bedded into a Boyds classic, and i intend to bed my other 110 in one as well. It shoots really well in the factory stock so i am in no hurry, besides the synthetic factory stock is a bit lighter to tote around.

 

[okie2]

can some one run a Quick load on this load for me?
tell me the fps of it.
22-243 Ackley
47 grains varget 40 gr Btip
26" barrel 1-14 twist

 

[FOTIS]

C.O.A.L. ???????????

 

[okie2]

2.570

 

[FOTIS]

OK pending on your case capacity this is what I got

Cartridge : .22-243 Win Ackley
Bullet : .224, 40, Nosler BalTip 39510
Useable Case Capaci: 49.385 grain H2O = 3.206 cm³
Cartridge O.A.L. L6: 2.650 inch = 67.31 mm
Barrel Length : 26.0 inch = 660.4 mm
Powder : Hodgdon VARGET

Predicted data by increasing and decreasing the given charge,
incremented in steps of 1.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !

Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms

-10.0 96 42.30 4022 1437 57867 8728 98.6 0.957 ! Near Maximum !
-09.0 97 42.77 4061 1464 59901 8783 98.9 0.943 ! Near Maximum !
-08.0 98 43.24 4099 1492 62005 8834 99.2 0.930 ! Near Maximum !
-07.0 99 43.71 4138 1521 64182 8880 99.4 0.916 ! Near Maximum !
-06.0 100 44.18 4176 1549 66433 8921 99.6 0.903 !DANGEROUS LOAD-DO NOT USE!
-05.0 101 44.65 4213 1577 68763 8958 99.7 0.890 !DANGEROUS LOAD-DO NOT USE!
-04.0 102 45.12 4251 1605 71174 8990 99.8 0.878 !DANGEROUS LOAD-DO NOT USE!
-03.0 104 45.59 4288 1633 73670 9017 99.9 0.865 !DANGEROUS LOAD-DO NOT USE!
-02.0 105 46.06 4325 1661 76254 9038 100.0 0.853 !DANGEROUS LOAD-DO NOT USE!
-01.0 106 46.53 4362 1690 78930 9055 100.0 0.841 !DANGEROUS LOAD-DO NOT USE!
+00.0 107 47.00 4398 1718 81701 9069 100.0 0.830 !DANGEROUS LOAD-DO NOT USE!
+01.0 108 47.47 4434 1746 84572 9082 100.0 0.818 !DANGEROUS LOAD-DO NOT USE!
+02.0 109 47.94 4470 1774 87548 9094 100.0 0.807 !DANGEROUS LOAD-DO NOT USE!
+03.0 110 48.41 4505 1803 90633 9105 100.0 0.796 !DANGEROUS LOAD-DO NOT USE!
+04.0 111 48.88 4540 1831 93831 9116 100.0 0.785 !DANGEROUS LOAD-DO NOT USE!
+05.0 112 49.35 4575 1859 97149 9126 100.0 0.775 !DANGEROUS LOAD-DO NOT USE!

Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba 107 47.00 4530 1822 94649 8794 100.0 0.780 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba 107 47.00 4203 1569 68693 9213 98.2 0.895 !DANGEROUS LOAD-DO NOT USE!

 

[okie2]

I THANK YOU A BUNCH
I just noticed the case capacity i measured last night is 52.2 grs of water
my 49.0 gr load blowed the primer
my 48.0 grain load was very accurate but showed a little sign of high pressure
protrusion in pin hole
so I backed off to 47 grains and every thing looks ok and is
still accurate

 

[FOTIS]

Good deal, stay safe and enjoy.