Recent content by 264 WinMan

I thank everyone for the replys. I have a lead on a stock at this time. I hope it ill work out. JMUPT if this stock that I am going to see does not work out I will be sure and get with you. Regards, Gene

Thank you to Ridge_Runner and Antelope_Sniper, that would make sense. So that brings me to the other part of the question, would the pressure window fall out on the opposite of the chamber for a right hand barrel on a left handed receiver? Also would putting another window in the barrel weaken...

I have a left handed Winchester Model 70 in a 300 wm. There is a hole in the side of the receiver at the end of the barrel chambering. 1. What is the hole for? 2. Pressure relief? 3. I noticed that a right handed rifle has one on the right side and the left haneded rifle has it on the left...

Thank you Scotty for the reply, I checked there and I did not see any.

Hello all, I am looking for a clean take off Remington Sendero stock early style without the fat palm swell. This would be for a Sendero II in a 300 win mag swap out. Let me know what you have. Regards, Gene

I thank everyone for their opinions on this 338-06. Listening to everyones ideas it makes me still want to have this cal. I am a person that likes to be differnt than everyone else especially since I am a South Paw. Everyone has brought up very valid points worthy of pondering which way to go...

What a great explanation! Thank you, now I see and understand.

Dr. Mike, Please elaborate.

Thanks everyone, Now I will sharpen the pencil annd put it to the paper. "I HAVE AN ITCH THAT I NEED TO SCRATCH". This set up sounds like the ticket I am needing. If anyone thinks of anything else by all means fire away.

Guy, I am sorry to hear of the passing of your friend. I do thank you for sharing your information on his gun. Thank you everyone for the information it gives me something to work with and pushes my idea of having a 338-06. OK, now another question as far as the differnce between the...

Guy, Thanks for the reply. Do you know if he had a barrel made or was that the factory barrel? When you say he had it throated for the 210 gr. partition, is that someting I will have to do having it specific for one gr. of bullet. Also would a 1 n 10 twist be good for 200 to a 225 gr.?

Would you build a 338-06 or buy something else? Can I take a Remngton factory 30-06 or 270 barrel and have it reamed out to a 338 and feel comfortable with the remaining metal? Or should I purchase a new barrel in a 338-06? The longest shot would be 200 yards max. I just want a gun that will put...

I would like to at this time thank each and everyone of you who helped with this problem I encountered. Thank you: NODAK7mm (Rod), Rick Smith, 6mm Remington, JD338, C. Smith (Corey), Pwerstroke, Desert Fox. My plans are for the 22-250 to use H380 with CCI 200 primers and Nosler 60gr...

Swamp Hunter 38 I ask this only because it just happened to me. Is the die going all of the way down on the casing? I had a problem with my decapping rod too far down. It would not let me completely resize the case. Not sure how far your bolt is closing but mine would go full length but would...

First off I must thank all for their replys. Real men of genius. NODAK7mm I feel for you on the cold temp. I have never been in that cold of temp, 8 degrees was good enough for me. WOW I removed the decapping rod and expander. I then took a case that had not been sized as of yet. I lubed it...