Recent content by Calvin

I purchased both the 45 and 40 undersized die from EGW. www.egw-guns.com I've used the 45 auto one for about a year with good results. i have the 40 but have not finished buying the rest of the dies yet.

My bad, I said it was a Lee Die, but was mistaken. My above post refers to the undersizeing die from EGW, which is describe thus: This has worked great in my 45 Auto reloads fired from a factory Glock barrel, but the 45 Auto is relatively low presure. Does anyone have experience using these...

I went for a VX-III 2.5-8 with the new B&C reticle, however, the balistic drop did not match at all to my disappointment. So I switcched to a VX-II in 3-9 I had in my closet. I would still like to gat back to a VX-III in 2.5-8 for the over all size and magnification range, but in the mean...

I have a G21 .45 auto and a much more experianced reloading friend steered me toward using the Lee small base die to resize my spent brass due to the factory barrel not being fully supported. I read in the previous post recomendations against reloading for the .40, and wonder if the cartriges...

i purchased a Tikka T3 in 300 WSM a couple of months ago and could not be happier with it , except when using a bipod pulled the front sling stud out of the synthetic stock from recoil. I screwed it right back in and it seems to hold fine for slings. I only worked up one load for it (180 gr...

I have not loaded this bullet in mine before. I have 180gr Partitions shooting very well through is, but wanted to develop a load around the 200gr AccuBond also. When I looked in the current manual, the only 200gr loading is for the partition. I imagine I could start there, but am fishing for...

I'm just moving Lodi Ca from Newberg OR. I'll finish the deer/bear/elk season out since i have my tags already before I call CA home :roll:

I could not get a new rem mountain rifle in .30-06 to give me decent groups 3 to 4" groups were consistent. I was shooting 180 grain partitions with different powder loads and all that. when i switched to 165gr, i started getting 1" and less at 100. Just a real picky rifle I guess.

Can anyone (Nosler?) help here? I've got a couple boxes and want it dropping between 35 and 45" at 500yds with a 200yd zero. This is to take advantage of my Leupold Boone & Crocket reticle.

I would like to see an Accubond in 6mm/.243 in 100gr to take advantage of the Boone & Crocket reticle within my Leupold scope. hope you consider it