I hope I have not asked this, if so I can't find it. I recently picked a new model 70 270 win, I have a bunch of 140 ABs to run, what will R17 as well as Magpro. Oh and I should run mag primers with MagPro? thanks
Cartridge : .270 Win. (SAAMI)
Bullet : .277, 140, Nosler AccuBond 54765
Useable Case Capaci: 59.393 grain H2O = 3.856 cm³
Cartridge O.A.L. L6: 3.340 inch = 84.84 mm
Barrel Length : 22.0 inch = 558.8 mm
Powder : Alliant Reloder-17
Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !
Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms
Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba 95 54.50 3135 3055 76513 11995 100.0 0.979 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba 95 54.50 2867 2556 50742 12872 99.0 1.157
Cartridge : .270 Win. (SAAMI)
Bullet : .277, 140, Nosler AccuBond 54765
Useable Case Capaci: 59.393 grain H2O = 3.856 cm³
Cartridge O.A.L. L6: 3.340 inch = 84.84 mm
Barrel Length : 22.0 inch = 558.8 mm
Powder : Accurate MAGPRO
Predicted data by increasing and decreasing the given charge,
incremented in steps of 2.0% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !
Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms