Thebear_78
Handloader
- Sep 30, 2004
- 3,114
- 985
A buddy of had to have this rifle that I had built a few years ago. Sadly he was unable to find re26 so he never even put a scope on it the last two years.
His needs had changed so he asked if I wanted it back. He needed a short barreled 308 for hogs and deer so we swapped barreled actions.
I picked it up from my ffl last week and dropped it into my KRG bravo chassis. I topped it with a 3-18x50 trijicon accupoint. Loaded up some 95gr SMK with re26 and took it to the range.
It’s still a tack driver! Three shots to get it close at 25, then fired a 1/2” 3 shot group at 100 yards. Adjusted to zero and shot a sub 2” group at 300 that landed right where it was supposed to at -8.2” low. I dialed it up .3 mrad and shot this sub inch 3 shot group at 200 yards.
I forgot how much I liked this rifle. I don’t think I’ll let it go a second time.
It’s a Remington 700 SA that was blueprinted and barreled by long rifles inc. The barrel is a 24” Schneider 1-7 twist with the p5 rifling in rem varmint contour. Timney hit trigger, KRG Bravo chassis and elite iron revolution bipod.
His needs had changed so he asked if I wanted it back. He needed a short barreled 308 for hogs and deer so we swapped barreled actions.
I picked it up from my ffl last week and dropped it into my KRG bravo chassis. I topped it with a 3-18x50 trijicon accupoint. Loaded up some 95gr SMK with re26 and took it to the range.
It’s still a tack driver! Three shots to get it close at 25, then fired a 1/2” 3 shot group at 100 yards. Adjusted to zero and shot a sub 2” group at 300 that landed right where it was supposed to at -8.2” low. I dialed it up .3 mrad and shot this sub inch 3 shot group at 200 yards.
I forgot how much I liked this rifle. I don’t think I’ll let it go a second time.
It’s a Remington 700 SA that was blueprinted and barreled by long rifles inc. The barrel is a 24” Schneider 1-7 twist with the p5 rifling in rem varmint contour. Timney hit trigger, KRG Bravo chassis and elite iron revolution bipod.